1000 miles and no issues with the trolly handle making noise. The screws do work their way loose and need occasional tightening. But surprised at how usable the handle is, despite the notable shortcomings.
I don't even finish watching it, I'll give it like and hopefully the video will get 4 views, just kidding, let it be 4 million, just so I wrote that you find a service that will allow you to promote your channel.
I remember back when the hoverboard first came out and i got one. Was taking it out for a spin in the neighborhood and decided to see how fast it could go... got pretty fast and then started beeping and just turned off on me. I FLUNG forward
safer way to open the lid is not to hammering with flat screwdriver as you can damage the rim, but remove both sides of bolts and a little hammer to the axe, then motor stator could come out to oposite side and youre lose bearing grip. Another note, when you put the lid back, hammer with rubber hammer and do not forget to grease around the rim to seal if from water ingres
Need better grip tires. I dont know if they have triple A grip tires for those unicycles. Would not happen with better quality rubber. Yoy want to be fast on one wheel. You better invest in the best grip.
Great video, but you did not mention what we can use to re-waterproof the motor drum. After opening it will inevitably make the waterproofing worse, so I would like to know how to re-seal it
Is there a way tighten the Gotway pedals so they are tighter when pivoting instead of flopping down fast? I can do it on my Inmotion which has a grub screw but don't see it possible on the Gotway
Exactly it very bad machine one wheel and if cut off electricity you down harder , one hole on public rd you going down like a clown harder . Finally better two wheels then one , even my nephew 10 years old know this . Finally it illegal on public rd . If Chinese decide to add barrier handle it can be more safe and legal and fantastic
Great video! I’m planning to replace the bearing on my Sherman Max. Which bearing do you recommend? How do you remove and replace the bearing without heating it up?
The foot stands are so low. This happened to me on a onewheel pint. The front is lower then a standard size so when going up a hill its barely any clearance. So i pushed it to hard and crashed.
What a butcher. Uses pliers as a hammer. starts cap screws into thread with electric screw driver. Applies no fresh loctite to stop galvanic corrosion and prevent galling while doing up stainless cap screws into alloy. Appears to tighten cap screws with ball end allan keys. no torque wrench, etc, etc.