HOW TO REMOVE A EUC MOTOR SAFELY *(beginner video) 

Thank you for this video 👍🏼 just learning to work on EUC’s so I appreciate it

Dude, You're awesome! Thank you.

thank you Paul for that video! cheers from Canada🤙🏻

Doing this soon. Thank you!!

Excellent informative/educational video!

f..g awesome! best tutorial so far! forever grateful!

Thx man, I will be swapping over to the wider Sherman rim and this vid should help me keep all 10 fingers intact.

safer way to open the lid is not to hammering with flat screwdriver as you can damage the rim, but remove both sides of bolts and a little hammer to the axe, then motor stator could come out to oposite side and youre lose bearing grip. Another note, when you put the lid back, hammer with rubber hammer and do not forget to grease around the rim to seal if from water ingres

Great Vid!!!

From Ewheels - Also, when installing the new rim, please ensure that the larger gap side (top in photo) is facing right, same as the motor wires. The two edges have different widths, if it is reversed, there may be motor power delivery problems as the magnets will not be correctly aligned

amazing share 👌🏻

Don’t forget to set the rotation on the tire right!😊

It looks like eWheels will be working on my motor if something goes wrong.

Really Good video great stuff and thanks for it ! 👍💪🤟

Great video! I’m planning to replace the bearing on my Sherman Max. Which bearing do you recommend? How do you remove and replace the bearing without heating it up?

Very nice - it's in my reference collection of videos :-)

I'm trying to replace bearings on my Abrams, I was able to remove one cover without even a screwdrivers, just used some thick guitar pick, then with a bit of heat old bearing slid right out, new one just dropped in when pulled out of the freezer. put everything back together without much problem. Then I started the other side and immedietely got stuck trying to remove the cover.i was able to break the seal no problem, with screwdriver method you show I was able to lift cover around the edges like 3-5mm (at any point, it's not binding anywhere on edge) but bearing wont let go of axle. its just completely stuck and I dont want to damage the rim by excesively wedging those screwdrivers. any tips?

Great video, but you did not mention what we can use to re-waterproof the motor drum. After opening it will inevitably make the waterproofing worse, so I would like to know how to re-seal it

I am a bit confused about the final pedal hanger tightening, is putting it in the pallet supposed to keep the hangers aligned? When I did this on my old Msuper I had the pedals into something like a workmate table to make sure they were even/parallel.

Would this be the same for inmotion v12 ? I need to change the bearings .

Watching this weekend! 👍

What is the ratio of motor : rim magnets. I counted 48 mags on the rim but couldnt get a count for the motor

Think there would be any detriment to using a washer with a slightly bigger hole or just drilling it out just a tiny fraction?

Elow sir i just remove my motor but whwn i put it back the tire doesnt move or run what seems to be the problem thanks

Where are you located? I need the motor for my KingSong S18 replaced.

what is the size socket to use on the motor and where do i find one with that slot so i can work around the motor wires?

Came across this video as I need to replace the bearing on my Nikola. Do you think I'll be able to get the bearing out without a torch?

I'm curious. Is there no seal between the covers and the motor?

Would be so nice IF you could do a maintence video.... How to provide problems.

the most interesting thing is removing the bearing cable side when it is on the shaft, the rest is mundane

Aii ... when the Dremel comes out .... not good.