Impossible creativity is the best place to access the information about homemade and remote control drones. Our main fields are of robotics, arduino, remote control planes, remote control drones and many variety of science and technology projects. We are working across the number of flight controllers, arduino sensors and equipment, rc plane models.
More about this channel...... We have worked in the different models of drone such as TRICOPTER QUADCOPTER HEXACOPTER OCATOPTER
We are working with the following different models REMOTE CONTROL DRONES REMOTE CONTROL PLANES REMOTE CONTROL CARS REMOTE CONTROL BOATS ARDUINO RELATED PROJECTS ARDUINO PROJECTS
hello. I hope you can give me urgent instructions I did everything like you, but a problem appeared: when testing the motor on ardupilot, I set it to level 5 and only 2 motors rotate. At level 15, the remaining 2 motors rotate
In actual testing, when starting, only 2 engines rotate at the same speed. When you pull the throttle strongly, the remaining 2 engines will rotate. Please give me the solution. I need it urgently. Thank you
Hello, everybody. I want to connect an MG996R servo to the Pixhawk 2.4.8 autopilot , to achieve continuous angular movement of 10 degrees right and 10 degrees left. I have powered the servo from the BEC of the ESC, and the PWM signal is sent from AUX1. I am able to move the servo through Mission Planner using the Servo Output tab by adjusting the SERVOn_MAX, SERVOn_MIN, or SERVOn_TRIM values, but I cannot achieve continuous movement. Is using a Lua script the only solution?
@@impossiblecreativity Bhai iske reciver me mene 12v dc gear motor 600 rpm lgayi thi but pehle slow chal rahi thi but ab chal nhi rhi. Aur transmitter ki mujse setting galat ho gyi hai please Bhai btao ki isko thik kaise kre. Bhai jab pehle 60 amp brushed esc se dc gear motor ko chlaya tha tab esc ki wire jo motor ko lagti hai current a rha tha but abb nhi. Please Bhai btao ki transmitter ki kya setting karni padegi
Bhai iske reciver me mene 12v dc gear motor lgayi thi but who slow chal rahi hai. Mujse uski speed Kam ho gayi hai please Bhai btao uski speed kaise bda sakte hai
Can we Set (connect) two toggle switch of Tx to Mission planner (Pixhawk2.4.8)?? Like if 'switch A' controls the Servo then 'Switch B' will be safety switch, If switch B is ON then only 'switch A' can control the Servos connected to the given channel. So we can prevent accidental control (or change) of the servos with 'Switch A'.