Just installed pke remote start alarm system like that on your video but the siren is not working and also the key pad is not working. Can you please help. Thanks.
In terms of keypad, it may have to do with one of the DIP switches on the main unit itself. I remember one of them controlled that. In terms of the siren, you’d probably need to install a relay. I’d suggest you speak with an electrician regarding that one in particular because every car is different 😅
@TheAutoDIYGuy Thanks again. I had my siren working, that was my fault. I thought the siren output wire was positive (+) but on my system it was negative (-).As for key pad it's also working too it's hard to change password. I'll try again and again till I get it.
What is that white harness with 3 wires (red, white and yellow) for and where to connect it. After installing system, the engine cranks but can't run. Please I need help. Thanks. 2:44
Only one problem with cheap easyguard start button system, after 6 or 8 months it fails withought warning, your engine just shutdown while you drive, after that i bought another brand called banvie, but after 7 monthd it fails also but different from easyguard, the HVA has been dissableb, no AC, no radiator fans also, you cant even notice that, because the engine keeps running, but i was lucky, when it happened, ut was summer time, and the AC stop working, and i notice the whole HVAC is not working, so i disconnected the start burton system, and start the car with the key, and HVAC comes back, if that happen to you on the winter or automn when the AC is not needed, your car will overheat, because the radiator fans are dissabled with HVAC, and now i bought and expensive easyguard start button system 130 dollar, amd now 1 year and 3 months and still working, of course i bought another one the same as spare. When it start failling, i will replace the black box with new one and problem solved.
If anyone is wondering how to add this to your car alarm system to pop trunk using remote. You need to buy a RELAY and wire it like this: Wire the Relay as such - Pin 86 & 87 to 12V Fused to Constant, Pin 85 to Trunk Release Input(trunk release wire from your alarm), Pin 30 to Trunk Release Output (wire from Relay to Green wire to Solenoid). Hope that helps.
Hi. Really nice idea. My ignitio nkey won't work properly, just in one position start the engine. I have the same car as you have, but it's a wagon. The central lock key is on the ignition key and also there is an Immobilezer. Should be the key in the key hole? Or this system can handle the whole thing? Thanks for your advice.
Hey, not sure if you still around. I installed the same system and everything works as it should. However, every time I arm the module, it goes off after 30 seconds. Only when armed, no shock sensor installed. Car locks/unlocks/remote starts just fine
hi! i installed on my fiat bravo essence, with manual transmission but remote start doesnt work properly. manual start by button "start" is ok and another functions also is ok but remote start no. the car engine starts but dead after some seconds. can you help me to solve it? p.s: my key chip is atacched to "ring" to recognize and allow the car starts normally.
Hello brother, my problem is that when I turn on the vehicle using the remote control of the module, the alarm works except for the driver's side. What did I do wrong?
Friend, I have a big doubt and a question if you can help me. My car has a remote start with an original factory key and I can start it remotely from my house with its key. I am going to use 2 keys with a chip, one for the chip that will always be placed in the ignition antenna (to be able to enable the button that I am going to install) and the other as a spare to be able to start the car remotely. My question is: will the copy of my other key with a chip work to start the car remotely from the house once the button and a permanent chip in the antenna are installed? Greetings
your videos are great. I installed the easyguard ec003 in a 2016 kia sorento, but I cannot identify the door opening and closing cables, the flashing light cable, the courtesy light cable and the trunk. Do you know where I can buy the Kia Sorento manual?
