I have an infiniti G25x and I am having issues with the left turn signal when I use the right turn signal it flashes normal but when I use the left turn signal it flashes both the left and the right and my screen inside the car flashes also would that be an issue with the fuses or relays and can I find the turn signal fuses in the same fuse box any help would be appreciated. Thanks
Question about the sensor switch. My car 213000 miles could that stop a engine pumping oil after reaching engine temperature . Wit h when turned off won't restart.. it like the battery is dead
I love the way you acknowledge our Lord and saviour Jesus Christ. That touched me. I appreciate you for spreading that message in your RU-vid videos. God bless you ❤
I to have a steering noise also lol but it makes a grinding noise when turning lol and greeting to all of my brothers in Christ Jesus! I hope all of you are doing both physically and spiritually healthy. I’ve been doing online service and it’s based in California. My friends recommended it to me when the pandemic happened. Also do theology studies on line~it’s an international study… kind of been doing all sorts of things to build up my faith. These are hard times but must always keep our faith alive and going to the end. God bless everyone ! 😊
Thanks for the air bag removal video on the Versa. It helped a lot. I had the Nissan instructions through Mitchell but that third release said to rotate downward and it would release. It is clearly shown that to be an engineer for Nissan you must first be a brain dead moron to make a system like that. Have released hundreds of air bags but never like this. Thanks for the help again.
My high and low beams went out only my fogs work 2008 Infiniti g35, I had water leaking in from sunroof and it was going right by that fuse box so i hope it's just needs new fuse and not fuse box and all.
Thank you I appreciate it tomorrow morrow I get into what I do I figure everything out it’s been very helpful welding Leticoe I don’t know how to do it but I do it I’ve been studying how I figure things out I figure it out if I can’t figure it out then I’ll look into it and I just figured it out and I appreciate your help and I do have a G 35 red San Marcos Texas fire hot have a wonderful day
You have to apply a bit of force to remove, also try to observe the wire at the bottom of the fuse box because it has a little curve that seems to hold it. Just apply the appropriate force.
Thank you for the video and encouragement in Jesus, I'm a believer also,only thing I would ask is show noise next time before showing remedy,thanks anyway though this was still helpful.
Thanks for sharing video. Big help. Now K tried testing and one of 10AMP. Fuse is not conducting when its in fuse box. But when I remove and inspect it, it works on multimeter and no problem ! So do you think its Fuse Box or Ballast ? Thanks
Thank you for your comment and question. You said that the fuse is not conducting in the fuse box, however when you remove and test it works. Did you turn on the head light before testing ? If so examine the port for the fuse if there is any corrosion if not replace the fuse and test again. What about the other fuse for the head light do they work? Do not change the blast or fuse box until relays, wire, fuse are checked out
The wires that goes into the fuse box could be what is holding it down, you will have to be gentle and play with it a bit, it will come out. Look for the clips ot tabs on the box to open it. Hope this helps
Thank you for sharing. I did the same for my 2015 dodge charger however I hear a clicking noise as I press on the break, I still get the P0572 code as well, any idea what to do next after the break switch was replaced? Thank you in advance.
Probably drain your battery sometimes that plunger get locked in it's supposed to release after you take your foot off the brake but if it's and that mean it's still using power
