After looking at your video 100x I feel confident enough to replace my valve body, I have a 2018 Nissan Sentra, it has over 160,000 miles…. We never got the fluid change to the transmission (never knew I had to do that) but my question is after watching other videos should I be concerned about that, because I will have to add new oil in the car, hope my question made sense.
I get a b1049 error... changed the clock spring and changed the airbag... i get 7 blinks in diagnostic mode.. people are saying it is that module now sad
Hope you can help I have a 2013 Altima 2.5 drives fine but after long trips and I get on a stop then take off is really slow takes a little to speed up and currently giving me code p0776 (fluid is a little brown)
Its hilarious..the hardest part of the swap you managed to skip over and not even show..you act like the nut was hand loose the entire time...FAIL...what a waste of time..
Hi, I have some issue with nissan sentra CVT. Can you advice any solution please?? 2013 model, 135k miles done, codes 1. P0847- FLUID PRESSURE SENSOR 2. P0963- PC SOLENOID A Have a hammering effect after these codes shown up and feels like cvt not shifting to higher ratios. Does a valve body replacement helps in this issue?
@@tryfixinit8438 I was looking for the best way to reinstall it after I removed it. I did figure it out. Currently I am trying to find a used valve body. Do you have any local recommendations?
Hi, I have a 2015 Nissan Sentra SV would the valve body be the cause of rpm being higher than the acceleration? Also, it just started not wanting to accelerate when driving even if I press the gas pedal all the ay down, then after a couple of minutes it will accelerate. I do have the code P2859A
My regular mechanic said I would have to get a new transmission but didn’t even check it, just said that because of the symptoms being experienced. Thank you
Can you program regular key fobs (NOT push button start) using the OBD star? I have a 2015 Frontier that I cannot get into the programming mode using the traditional steps and I was thinking that maybe I could use OBD to do so..
I have a 2010 nissan rogue cvt level is good but 80% of the time when shifting from P to R or D it shifts pretty hard, any idea if a bad valve body could be the culprit? (Mounts are good)