My Ugly catfish rod 7" medium heavy is nice with a baitcaster got it for Christmas and got a 4lbs catfish so for but great stuff for Bass fishing 🎣. Just a fun and good rod. I want something for trout fishing. I got 3 GX2 very happy. They don't have Shakespeare logo on them the GX2 reel's best.
I got 1 but mine is like 26 ft long and I got 4 jetskis on it .. only thing I hate about the trailer is the hydraulic lift it gets hot asf once I’m coming back down with 2 skis in the front then I have to back in a little more just to keep the skis leveled while I put the other 2 on
I have 2 of them on my boat, but the knows broke and all I have is the pins that the knobs were on. Can you buy the knobs to replace the broken ones?? Thank you
U first pull out the tilting pin once ur backed in the water with the tires about half way this works better if u launch in shallow water .. In deep launch Slopes u don’t need it … but in like 2/3 feet of water where the trailer is in the water and the jetskis or boat is not above or on the bunks already u have to pull the pin attach your winch and crank her up on the bunks .. once the boat reaches a certain point on the trailer it will push it self back down and u will be able to lock the tilting pin back in place and u can leave the ramp
You repeatedly said this is just a wood black with a "high tooth count." But you previously said it was the high tooth count (smaller teeth) that got clogged up on your other blades. So I thought "high" tooth count means more teeth = smaller teeth = finer cutting. Low tooth count means less teeth = bigger teeth = more spread out = ripping wood. You are more experienced than I am so you're confusing me. I'll have to watch again, maybe I missed something.
Well, I had been wondering how I was going to cut my 0.25" x 3.5" x 3.5" aluminum angle. I needed the cut to be perfectly square. Went outside, set my Dewalt radial arm saw up and went to town. It took longer to set the saw up than make the cut. Cut it like butter and perfectly straight. Thanks for this video!
Set the depth of your blade barely past the depth of the material being cut. This will disapate the heat away from the blade and the material being cut.
Wow, I smiled through out the whole project. It’s always amazing the motivation when doing it right, a dream provides in completing a project. Congratulations on a fine looking boat.
I have not ran this motor in a long time but it ran perfect last time i used it. I cleared the fuel system before storing it in my shed. I have no doubt it would start right up.