Some model years of this same generation don't have the drain plug and you have to remove the entire pan, but you can buy a new pan that has the drain plug to make future fluid changes easier.
My man🎉, almost got a new washer. Worked on my greenworks.I also put some wd40 in the gun mechanism with it turned upside down, pulling the trigger a few times.
Your video is quicker, clearer, better presented and easier to understand than most of these “professionals” pages and channels. Great stuff, subscribed!
This is usually an intermittent problem. The pressure sensor jumps back and forth between high and low. I just use the black circular pattern tip and it always works. The yellow tip is hit or miss.
I seriously thought your video was going to be like another reddit where people post things that dont work. But i tried it and soaked for 15 mintues and sure enough, it worked. Thank you so much.
Did your car jerk when accelerating from a stand still by any chance? My trucks making the same noise and I’m not sure whether it’s my differential or what
Wish I saw this first. Took everything apart on mine and can't seem to get it back together. Was hoping to find a video that would show me what I'm doing wrong. Instead I found your video which just made me feel stupid instead. lol
Wow. Thank you so much for the tip. I had the same problem develop in the middle of my project. I was about to go out and buy another power washer but thought about checking RU-vid before I went. I consider myself so lucky to come across your video. I was having the exact same problem. Problem solved. Thank you again for taking the time to share your experiences with us.
Ours did this right out of the box. Then it suddenly started working. Then the next time we used it did the pulsing. I am reluctant to try another but my siding is screaming for a cleaning.
My mechanic doesn't like the hose and quick loc fitting deal. Says it will eventually leak. It''s a dealer only item. I'm looking at around $184 for the hose
I had a Sun Joe pressure washer with an adjustable nozzle that was doing the same thing. It hadn't occurred to me that the nozzle was restricted because it was still flowing, just pulsing. I thought the pump was bad. Your video clued me into what was going on. I soaked mine in white vinegar and water and now it works like new. Thanks for posting this video.
Didn't work in my case as all nozzles produced the same pulsing. Ended up upgrading the hose, gun, and nozzles to a better quality universal setup. No kinks in the hose. Pulsing instantly went away.
Ordered some plugs as well but threads are packed with carbon. Another thing you can use is an old spark plug. Knock the porcelain part off and the threads are same pitch. Can also cut threads in old spark plugs to make a cheap tap / clean up thread with.
So basically it's no good when somebody else has it married to there car as I brought one and its still Married two there car.left it to his car it has 5 unmarried left but cannot Load on my car up which is a Ford ba Turbo is there a way to unmarry it at your home
I have a Nissan Altima 2008 S 2.5 with 183,000 miles CVT. Should I change the transmission fluid? Many people have told me not to do it because the transmission will fail in a couple of days or months. What do you think? Thanks.
Not true.. All transmissions require fluid change. Even sealed transmissions. Sealed transmissions just means there is no tubes in the engine and you may need to drop the whole pan to drain it. Just make sure to use CVT NS-2 fluid if the car 2006 to about 2010.
Hey man, I'm pulling my engine and Trans, I know I need to disconnect the drivershaft from the transmission. I was wondering if you placed your jack stands under the rear axle tubes? Is that safe?
Inspired by your video, but found a much easier way. Just took one tip reverse blew out other tips. Rotated through all of them, and all working now. Wear a glove to protect hand.
