Wonderful video! Japan is always an amazing experience. I don't mean this as a criticism or to call you out in anyway more just for info. But it's highly illegal to use walkie-talkies in Japan and if you get caught it's a huge fine. You need to get a dedicated raido for Japan that you can only buy there and you have to get a license or rent them.
Thanks for the tip Jeremy! I definitely did not know about this….luckily we didn’t have to use them. Next time I go I’ll leave them behind. Crisis averted haha
Thanks Rhett! Yes, it is documentary style with a splash of a section catered to “internet style” specifically for RU-vid. Gabe did a great job with the GH4
you showed nothing about re-installing the pull/push light knob?!?!? Mine will not re-engage in the switch - just pulls totally out every time. What did you do?
Kerry. I believe mine just fit right back in. Maybe make sure your release button isn’t being pressed (or jammed) at the same time as re-installing the knob
@@amberofalltrades6891 Grind part of the plastic off the pull nob , along the metal shaft. Had the same trouble with mine. THe plastic hits the dash plate
@@jamesvaughan1560 I ran into this same issue with the pull knob not engaging when mounted in the dash. Ground about 1/8" off the plastic knob with a Dremel, and it finally clicked. Thank you very much for this suggestion.
West mountain is not as big, but if you’re into tree skiing the trees will have powder! On a pow day recently I switched to West Mt. and the trees were untouched and very spaced out at 1 PM. It’s not as steep as East Mt. and the runs arent as long but if you beginner/intermediate or intermediate you’ll have a ball. Heck I’m advanced and had a ball. I’ve got a video soon about my day on West Mt. Subscribe and stay tuned! Also, hope you have a refreshing/thrilling time here….I don’t want to leave ;(
Epic! I’ve been trying to find other Black female snowboarders! I’m going to visit Japan a year from now (couldn’t go sooner cause of college lol) this looks so dope
I’d say we out here….but it’s very far and few between these mountains haha that’s why I decided to start making videos. Gotta let the people know 👏🏾 Have a great time in Japan….the most expensive thing about it is the plane ticket. It’s SO cheap here I swear.
UPDATE !!! I just finished replacing the light switch on my '96 Cherokee. I have replaced similar switches on different trucks. The switch on my jeep COULD NOT BE REPLACE FROM BELOW THE DASH. I pulled lower dash and began the process as I have done before. With the retainer nut removed there was maybe an inch of slack wiring harness allowing the switch barely an inch of movement. No way to disconnect and remove the old switch, and definitely no way to install the new switch. I started pulling down the far left idiot light panel, discovered that is riveted into place. Then went after the instrument panel. pulled instrument panel bezel, and instrument panel which also required removing trim from the steering column around ignition switch/hazard light panel. (you will need a t-20 driver, and not a t20 bit on an extension) It was barely possible to replace the switch going in through the instrument panel location. New switch had 2 grounds, old switch and harness had one. Had to fabricate wiring, you will need 2 spade female terminals and wire. Doable, but major P.I.A.