How to change 1996 Jeep Cherokee XJ headlight switch

Подписаться 26

Просмотров 1,2 тыс.

50% 1

Problem: Parking and dash lights worked with 1/2 pull, but if I pulled the switch all the way my headlights would turn on and dash lights off.
Most likely if you’re having headlight/dashboard issues it’s most likely the switch and it’s an easy fix!

Опубликовано:

11 июл 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 7

@user-ho4xq1io6s 6 месяцев назад

This was a outstanding video on the removal. I would of included the full removal, however it got me to where i can get the rest.

@freebuilder007 Год назад

UPDATE !!! I just finished replacing the light switch on my '96 Cherokee. I have replaced similar switches on different trucks. The switch on my jeep COULD NOT BE REPLACE FROM BELOW THE DASH. I pulled lower dash and began the process as I have done before. With the retainer nut removed there was maybe an inch of slack wiring harness allowing the switch barely an inch of movement. No way to disconnect and remove the old switch, and definitely no way to install the new switch. I started pulling down the far left idiot light panel, discovered that is riveted into place. Then went after the instrument panel. pulled instrument panel bezel, and instrument panel which also required removing trim from the steering column around ignition switch/hazard light panel. (you will need a t-20 driver, and not a t20 bit on an extension) It was barely possible to replace the switch going in through the instrument panel location. New switch had 2 grounds, old switch and harness had one. Had to fabricate wiring, you will need 2 spade female terminals and wire. Doable, but major P.I.A.

@amberofalltrades6891 Год назад

Wow what a process! They really have NO room to maneuver….luckily I have long skinny hands. Glad you found a way!

@kerryahlstrom352 8 месяцев назад

you showed nothing about re-installing the pull/push light knob?!?!? Mine will not re-engage in the switch - just pulls totally out every time. What did you do?

@amberofalltrades6891 8 месяцев назад

Kerry. I believe mine just fit right back in. Maybe make sure your release button isn’t being pressed (or jammed) at the same time as re-installing the knob

@jamesvaughan1560 6 месяцев назад

@@amberofalltrades6891 Grind part of the plastic off the pull nob , along the metal shaft. Had the same trouble with mine. THe plastic hits the dash plate

@DJMHR777 5 месяцев назад

@@jamesvaughan1560 I ran into this same issue with the pull knob not engaging when mounted in the dash. Ground about 1/8" off the plastic knob with a Dremel, and it finally clicked. Thank you very much for this suggestion.