I have 2003 envoy xl sle ,4 wheel drive I need this exact thing fixed ,but i never see a video about envoys only trailblazers or even in my search trailblazers show up , but they are so similar, and I want to do this myself ,all lights are on except for my parking and mileage shown here.How can i fix this problem, I might have electrical as they are kown to have ,not everything is workig or not all lights out and comes on but this went out over a year ago and never came back on.??
Looks like you mounted the clamps on backwards... I bet you often get hung up on the pieces sticking that far out from the back of the transom. Also, you don't have any controls on the arm?
Try working in some Neatsfoot Oil into leather side, not flesh side. Or better yet Lexol leather treatment with Neatsfoot Oil in it. Work it in and squeegee it off, then dry the excess off with a paper towel. That should protect the leather and keep it pliable.
Hmm after tanning (egg tan 6 egg yolks and 2 cups water) I let it dry. Then oil with mineral oil until the tail leather stops drinking it and pools on the surface. Once that happens apply taxidermy sawdust and rub with a board for 4 hours or so until dry. Repeat on the other side...yields an amazing leather.
I did the same kinda build n i also chsnged my rear tire to 16" doughnut fromthe trunk of my car lol it fit too!!!! Yry it u wont ever have provlem with fkat tires
Thanks. Ridiculous though. What a terrible design. I saw another video where a guy just drains the oil out the oil intake from the top by turning the machine upside down.
Ive seen just putting them on lathe but this is a simple easy and cheap method, I like it! Im looking for different methods for 1.5 CS rather than buying the hagz...any ideas?
Before cooking. If you have the time and the means. I’d par boil it for five minutes. It’s not necessary. But like I said. If you have the time and means.
I use the same solution to tan with , There is one thing you can do it is to not let it dry out after you take it out of the tanning solution , You use Neatsfoot oil and water 50/50 mix and heat it and put in on the leather side. and let it sit overnight and then work the skin and then do it again with the oil and sit over night. I found you do this 3x then you keep working the skin till it is dry and then for make it more flexible you use medium sandpaper on the leather side and sand it some not alot or hard , then you are done. This is the old method to tan any skin, including fish . I use it when I do taxidermy . But I do not do the neatsfoot oil and let it dry I put the skin when wet on the artificial body and after it dry out it will shrink on you like you seen in the video when you let it dry . Then I just finish the mount.
I worked on a mink ranch and have skinned thousands of minks. Had to laugh at what you call a tail stripper. We used one too, it was called a cloths pin. Oh wait,, I'm sorry, no one knows what that is anymore. Lol
*Built well, **Bestfor.Garden** also recommend plugged right into my rider 4500 series. Was short the rubber cap key and was was sent right out in the mail. Just ordered another ignition switch for my 6500 rider.*
