Thank you for this video. I needed to buy a dryer but had no 220V outlet, forcing me to go with a gas model. When the delivery/installers arrived they would not complete the installation because I did not have a shutoff valve. After watching your video I am happy to report I installed it myself and did not blow up the neighborhood.
Awesome job very informative! If I may add just for future purposes those channel locks need to be opened to properly fit the fitting(s) thus giving you better grip! Have a good one!
instead of using channel locks to remove the cap use a pipe wrench. faster and sure grip. Also instead of using yellow teflon tape only if u use the yellow teflon tape then put pipe dope on as well u will have a fitting that will garauntee never to leak. for leak detection Hercules Mega bubble leak detector is the best leak detector it will detect the smallest of leaks.
Can I reset the DIP Switch Sequence on the Opener meaning flip on/off by myself not follow as the one set by the manufacturer setting. Then set the remote control to match it?
Great video! I especially liked your tip about being sure the faucet nut was only touching the sink! The only thing I'd add is when reattaching the sprayer, ALWAYS hold the tube you're inserting it back into!!! The leverage you're putting on the tube can eventually loosen or break it at the sink. For that matter, you might also be careful when you pull out the sprayer. That leverage on the tube, being so far from the sink connection, can eventually cause problems. Happy spraying!!!
I’ve had my new faucet for about two months still in the box. I’m going to attempt to put it in. Just need to figure out how to get the old faucet out. Fingers crossed! Thank you so much!