These calipers never come painted from factory.

10 out 10

Good job 👍

Tip: instead than cutting the maskingtape, slighly hit the edge with a small hammer. The rip what you don’t need, off.

Congratulations for this magnificent work good day

Appreciate the dedication and time. ❤❤

the music is a bit much

Bravo Goodyear job merci

Nice but its a ford... so will be fucked again soon.

Lots of work for something people never see. A proper sandblast is good enough.

How long does it take to bake the paint?

How did you protect the coating inside the bore, which is the most important bit?

Just get a helper to pump thr brakes and hold brakes and then release bleeder and repeat until no air bubbles

You don't put grease on the piston the dot3 or dot4 fluid is what lubricates the actual piston it's useless to lube it with that white grease.

Are you fucked? Squirting brake fluid down the sink?

So you cut out the ONLY part that I cared about - sliding the little part of the gasket inside the caliper when the piston is inserted.........

How long on bake time should be done?

GUYS .. Don't trust a guy supporting a car on a jack, let a lone a cesser jack! with no jack stands or at least a tire under the car. If he doesn't know these basics, you shouldn't trust whatever he says, even if it looks and sounds right.

What kind of paint products were used in the video and where can i get them from?

why did you paint the pad slides?

what was baking temp and how much icing lol

Great result! How long did it take for the lemon acid to remove the rust entirely? You also heated it, what was the temperature?

A bunch of perfectionist criticizing a guy for how he painted his brake calipers.

Kaliteli ve temiz iş, işini iyi yapıyor

How can you find 0,9 liter of fluid in your brake system? When I change fluid (by bleeding the brakes with brake pedal) it use to be max 0,2-0,3 liter of dirty oil. The lines and brakes contain very low volume, biggest part is in the tank.

That isn't Rusty. That's just a normal caliper. They all look like that at around 250k miles.

Надо сделать еще одно видег, чтобы показать как они выглядят через год использования

What is that awful jungle music? Good video, terrible audio.

Or you could get a life 😂

Dude horrible music for repairing...

Please....no crescent wrenches on a bleeder...use only a six point wrench or socket.

These were NOT in need of restoration lol

Резьбы закрывать надо когда красишь. Лучше туда МС1600 заложи, она не поднимется тормозухой

Do you want fries with them callipers

Limon acid please ?? Link ???

Обязательно в духовке их запекать ? И сколько по времени нужно ?

Tout simplement magnifique mieux que du neuf

Лайка не будет Музыка просто ужастна.

По венику в углу гаража, сразу понятно шо видео снято гдето на просторах снГ

What's this brawn thing on caliper?

You lost silver coating from piston channel.

can I use a compress to push out the cylinder?

The caliper is worst.

Do the same with your master and slave clutch cylinders if you have manual transmission

3:10 cheers mate

what kind of paint did you use? I've been told you need a special high temperature one and even then it doesn't last... How are yours after a year or so? thanks.

Only way I would have clicked off faster is if you played Taylor swift in the background

Great video, thank you so much. Do you boil it in lemon acid or do you just let it soak in the acid for 8 hours?

How long it take in the oven?

Great Job ♫♫♫