10.41 into the video you did a test run of the motor.. It looked like it was off-balance and had a small wobble. This is not safe.. Also, your battery pack is a fire waiting to happen. Don't leave this thing unintended in your home even if it's not being charged. The whole thing of a death trap. But,,, at least you can say you tried. 🤓
i see everyone changing sprockets, why notjust leave the larghe one from the peddle on and have geared back wheel sprocket? there is more than enough torque on the motor... what you did there is a waste of time. leave the small sprocket at the back.
I just dont get why his using masking tape to cover the battery's up surely that's a fire hazard it's not made for that masking tape is made for painting lool 😂😂😂
The loose dangling finger socks of your glove can get caught in the saw teeth and with them two or three of your fingers. It is costly trying to sew them back together you know.
Put a dual chainring on the front and a 7 gear derailleur setup on the back Moosehead motor to the outside of bottom bracket put the cranks back in get a second chain then make a short chain to go from the motor to the smaller front sprocket and a longer one to go from the other front sprocket to the back derailleur like a normal setup so you can leverage the gears and get a lot of more out of that likely 10 or less newton-meter motor just like a typical mid-drive with gears like all the cool kids have instead of direct drive with no gears and your fuel put free wheel on your cranks it should feel quite natural when you're pedaling and when you're not I think but you know a lot more about bikes than I do so I'm pretty confident you'll figure that part out
Ruedas de hoverboard. En mercadolibre venden ruedas o el hoverboard a buen precio ,..de ahí partes , ahí mismo en mercadolibre venden el controlador y acelerador.
i wonder if i can just simply put a hub motor and the stock hoverboard esc and bypass the on/off thing and manually put the sensor on the bike pedal so i just move my feet to move, im so stupid and smart i just might do it and i get a free battery pack installed that has a charging circuit
@@jgprojects912 i have power Bank in which I can give maximum 5 volt 1 Amp input and there are 4 batteries of 2600 mah in power Bank, there are two output points to power Bank one is 1 Amp and second is 2 Amp, so please tell me which diode and which fuse i should use, thanks
Invertí las relaciones pero atrás ponele una con velocidades de esta forma no le costará al motor lastima y agarra más velocidad. Si tenes la otra llanta ponérsela en frente. E irá más rápido y no costará la salida.
Y otra sugerencia a todos esos cables sueltos les hubieras puesto y uno grueso de color negro un fideo grueso donde estubieran todos los cables y te evitas meterlos todos juntos por el agujero
Todo esta muy bien hecho excelente pero por que no pusistes el chucho de encendido de la yave en el manubrio es mas facil por que si la llave se afloja se cae y pierdes la llave
I set up the same circuit with Tp4056, but when I connect the plus and the minus in series, the tp4056's light turns red and does not work, it cuts the voltage.
