Hello, tiking always. And 1 tik it will heet n nxt tik seems like cut off. Seems like on and oFf every seconds. It's getting hot but slowly. Can you please help. Thanks
mera machine ka inlet direct ho geya. power on karneke sath sath valve active ho jata hay. may ne inlet valve change kiya, valve ic change kiya resistor check kiya jo kharap tha who bhi change kiya.phir ye problem aaa raha hay. kya kar sakte hay can you please explain me?
same problem facing. but my washing maching work perfectlybut only inlet valve not working. but when i put water manually then it wash everything perfectly. I changed the inlet valve ic but still not working. what should i do?
@@technoolab3514 but drain motor work perfectly but inlet valve not working. i also changed inlet valve switch but still not working. i tested the voltage of inlet valve that is showing 000
I have same PCB board in machine. Everything is working but during washing and rinsing the timer gets stuck and blinks once every motor trigger. In short it keeps on washing and rinsing with a relay trigger sound and all lights blink once ever trigger.
Panasonic front load washing machine NA123 vb3 shows 'END' message as soon as the wash selector is set and door is not locked with outlet motor starting. Pressure sensor is good. Pcb board no AXW24V-18738
I have E1 error code, checked with 10k resistor, and bought a new thermistor, but it was not the problem: 240kOhm @ room temperature is ok. The problem is at integrated circuit in main PCB. Analog input AI3 (P63) should be high impedance (it is also tristate digital I/O), but it was latched at Vdd=5V. Solution A: replace main PCB (150€). Solution B: desolder pin 51 (it seems to work, I do not know how reliable). Solution C: replace thermistor with 10kOhm resistor or even thermistor (but then temperature readings will be wrong, i.e. insecure operation, discouraged the use of convection, only microvawe). Look for C139ST service manual, very useful for me.
Sir one problem is in LG TOP LOAD washing machine inlet valve have continous supply when machine main supply on means water continue on so if i checked at valve continous supply shown so pls suggest solution is it possible triac is on when main supply on. Is it possiblw when triac shortckt it may continues on?
Yes Mr Mike, For ruling out sensor causing E1, cavity sensor can be by passed by dis connecting the sensor and connecting 10k across the sensor connector.
Sir, I have similar problem. Everything looks perfect on tge pcb, but tge drain motor and pump are not working. What could be the source of the probkem?
I bought prestige induction stove today online.when I connect the plug to power it made sound first time.induction stove is heating for 5-10 seconds after that it is not heating.i used junction box also still no use.some sort of sound is coming from inside the induction like screws sound and parts are sticked.please give solution
Hello sir... My board is same sir..... Problem is water valve not opening sir... Valve changed... But no use. Power continuesly coming to valve... Sir but how much voltage coming to valve i don't know sir... But valve not opening.what is the problem sir
Sir mera yahi pcb hai but usme inlet valve direct on ho raha hai, inlet valve ka trasistor bhi ok hai dusara laga ke bhi dekha but same problem, please solution please
For the non technical user, if your stove is continuously beeping and not heating it’s usually due to two things: 1. Your cookware is made of non induction material such as aluminum, brass or copper. Electrical induction stoves work well with stainless steel cookware. 2. Your cookware doesn’t have a flat surface so it’s not touching enough of your stove to start heating. And one more, altho this is obvious for most people, you haven’t placed any cookware on the stove or you’re misplacing it (not aligning it correctly with center)