Thanks for the video man! I got 1 question tho... How do I set up lights on auto but that they shine all the time? (in my country lights have to be turned on all the time..) Do I set it up in the middle of the day or at night? And I go from Auto-daylight-auto?
Ok so I tried setting it up, and tried to "set" the sensor on bright day for it to turn the lights on... but it doesnt turn them ON... Only turns lights ON if I cover the sensor so its "dark"... but I want them to be turned on the entire time.. Any ideas?
Okay, But after entering the new E-step value. You didn't run the test again to show if it corrected it or not. If it didn't then you'd have to do the calculation again with the new values and retest. Also you didn't store the new setting.
Helped me out doing mine. Great video and straight to the point. A lot less stringy on my Ender 3 Neo 3D. Steps is under a different menu but it's there :) +1
Hello I just received the switch, I'm not sure how to set the coming/leaving home, can you explain to me? The position only works for me when I unlock and lock the car, but the low beams don't work
for home feature mine has to be turned from the auto position to 0 position twice with ignition off. So it goes auto,0,auto,0,auto -> light should flash-> Then if you turn it back to 0 after 15 seconds the coming home feature will be setup to 15 seconds. to disable it you need to turn the knob to 0 within 5 seconds in this state.
I’m doing this now. On my daughter’s 2005 VW bug. This is a total pain in the ass we should have just sold it. 8 hrs into it and i almost have the box out to replace the heater core. Now the pain of putting all of this shit back together never again.
Appreciate the video. I am just getting into 3D printing and have much to learn. I can tell a huge difference in just getting this extruder calibrated. Thanks again.
If your PVC is broken/stuck/clogged, yes. If you do this and it pumps out smoke, you have excessive blow by. The problem would probably be in the pistons.
Hi Mate! Can you help me out? My car is a VW Virtus mid trim level, and i upgraded the headlights to the top spec trim one. I'm facing an issue where the DRL's are switching off when the headlights are on (DRL's working perfectly when headlights are off). Need both DRL's and headlights to be 'ON' at the same time. Using OBDEleven i went into central electrics > Adaptations > Leuchte4TFL LB43 > then couldn't find the setting?
Man I have been trying to figure this out for forever, could never figure out those included Chinese instructions in the manual. I would accidentally turn the headlight knob and hear beeps, I was like what the hell did I change now 😂Thank you so much.