Excellent video, I have a question: is there a right and a left bushing, or are they the same, it would only be buying 2 to replace. Or is there one that has a different right specification than the left?
I have a 2013 gs450H, what can I replace my sub with? It’s not blown or anything but when I have it turned up to 58 it sounds floppy when deep bass hits.
Great video- I was able to change the tail light in about an hour, but it’s a tricky job. I recommend a magnetized 10mm socket so as not to drop the nuts. Also, sliding the new light into place took about ten minutes of fiddling. But glad I didn’t have to go to the dealer. Total cost was under $100.
Many thanks for the excellent video. One question: is there any difficulty in detaching and reattaching the weather seal? Any clips we should watch out for? Or does it simply slide back into the channel?
Bruuuh, what the hell? The repair manual asks you to remove the engine and transmission, and the few RU-vid videos on 2012-2018 models get complicated removing suspension components and raising the engine. I've always thought there's gotta be an easier way to do this job, these bushings handle hundreds of pounds of force on the daily, they can surely handle some twisting and pushing to get it in please. Please tell me it is this easy 😮 I have a 2013 toyota avalon
The way that is shown in this video is the shortcut way. It works beautifully if the bolts are not rusted in place. The issue is, if the bolts that hold down the bracket breaks, then you have no choice but to remove the engine to get access to remove the broken bolt with bolt extractors. So before attempting this, use lots of PB Blaster or liquid wrench for several days to fully penetrate the bolts. Then go very slowly on the bolts. If they don't break, then you are ahead of the game.
Hi Muhammedzain4089! Sometimes, If one or more speed sensors are completely damage it could show symptoms that will have a direct impact on an automatic transmission. It could signs such as hard shifting, limited gear operation, delayed shifting or rough shifts. I will recommend on scanning the car to see which one is damage. Also, check the wiring on the speed sensor its no damage and measure the voltage on the end of the connector. Hope this helps!
Hey man it’s hard to get to the third brake light to get it unplugged I did every step but I can’t reach to the third brake light and I can’t unplug it how you showed me any other way I can do it?
It would be real helpful if you would describe the details of the tools we need for example 12 mm socket, suck it wrench, Phillips screwdriver. Thank you
Hi! The tools are listed on the second 21. Only tools needed are phillips screw driver, wrench with extension, #10mm and #14mm sockets. Thank you for watching!
Hi Justine! Did you replaced with original coils? Sometimes chinese aftermarket are not good and it would not work. You could also have a mass flow sensor dirty or complete damage. It can be clean with mass flow air sensor cleaner wait until it dry complete then install it back. You can buy it on auto zone for $6-$10. Also, I recommend to check the motor air filter. If the filter is dirty it needs to be replace. Hope this helps!
I think it's perfectly fine to get to one mount at a time, all rubber is expected to be replaced eventually on the car but If your problem goes away it's great otherwise it's sure to help atleast if it doesn't solve it
Hello, thank you for your video, do you have a video on how to change the rear fog light on passenger side on a 2008 Toyota rav4? I cant find anything…
There is no fog light. Side light, blinker and reverse light. The stop/running light is integrated into the case and is not replaceable. The entire assembly must be replaced.
Hi Rey! I will recommend to use the ratcheting wrench 12mm on the driver side and if you have a really small 12mm socket on the passenger side will help. Thanks for watching!