Hi, thanks for your video. Could you please share your gimbar parameters? I've calibrated my sensors and now they are out of sync. Not sure if there is anyway to back to factory reset. So I guess if you export and save your parameters in a file and share it here it will fix my problem. Cheers
With gimble turned on the view looks ok so far. U should have showed us how to flash and feed the firmware into the chip too, so how a newbie person would make this project 😇
hello buddy , i did exactly as in video ,but the roll over and pitch sticks are not getting calibrated , speed and yaw stick works well , kindly advice
Third vid I've seen - the maker of these vids seems to be obsessed with 'Delta' and 'V-tail' aircraft. These are specialised aircraft, and a long way from the standard aileronr,elevator and rudder setup that the vast majority of aircraft use. Why not show how a 'normal' aircraft is set up,please?
If your model is programmed in the tx to delta do l have to disable and let the giro do it ? Or can l leave it and just plug the giro in ? Can’t get mine to operate correctly?
Ok thanks. I got it to work in the end by trial end error just had to disable the Elveron mix in TX . Never used one before to be honest it’s off most of the time because the amount of gain l have to use to make it viable causes ridiculous control surface flutter🤦♂️
The video claims to show how to upgrade 6 to 10 channels. However, you start off with 10 channel. How exactly does this explain how to make the upgrade? If you change the title it would be a good video.
Tip: 1) If SmartProPlus never connects to your transmitter then the most plausible cause is you are trying to insert the 3mm jack as shown in video to 3.5mm headphone jack in your laptop. The 3mm jack is detected as speaker. In order to use the 3mm jack in 3.5mmheadphone jack as microphone you need to 3.5mm headphone jack to microphone and speaker splitter. You can get it dirt cheap. 2)If your transmitter connects but the signal fluctuates too much then go to Manage your audio devices and then choose your external microphone and then decrease its level. The lower the level the more stable will be the signal. Hope it helps!!
What is the wing loading? And informing as a highly experienced in Aeromodelling of 1970 till now what AEROFOIL SECTION u r Used ? Also informing you that u must COVER all instruments by adding a like Cockpit at centre part. Then flying of the model will be Drag less .
Hi bro. im looking forward to build my own voltage sensor. may i know what PWM output signal it gives from this sensor for each voltage if you still have this.. i can build this sensor with external voltage sensor for Arduino.
The biggest problem with the Jumper R8 is that they seem to have a quality control issue. Most of the RU-vid videos, and uncountable forum discussions about defective R8 receivers. I boiught one and it's defective too. It's half the price because you have a 50% chance of it working (maybe.)
Very good and helpful. When I tried my Flysky PPM to Mic input in windows 10 using SmartPropoPlus, the signals are flickering. Any reason ? And how to fix it. Appreciate it.
