Do you need to do any hardware mods when adding pops and bangs? Something with the catalytic converters so that they dont get clogged up? Or you just plug and play
Ok so my headlight, brow, and hazard light works it’s only the halo that’s out. It’s no bulb to replace it because my e93 is lci so which module or ballast do I need
Unbelievable, a headlight used to be removed with a screwdriver and take five minutes, now you need an engineering degree to change one. I working on rebuilding the ones on a 2003 530i, new adjusters which of course were all broken, new lenses and HID bulbs, I don't even know if the adjuster mechanism works or how it works, as long as I can get the lights stable and not wobble about they should be good.
What is the point of explaining some screws that cannot be seen because it is in front of the sunlight, then it does not explain all the screws to be removed except that you do not have the lower ones because you have lost them, most of them come as standard and then there is the update part the unit, a video for BMW naives that makes those of us who already know what this task is about laugh.
hi, i have a bmw 323i e90. the lights turn on but remain pointing towards the floor. the two at the same time began to do so. It's pre-facelift. It doesn't have a screen but it doesn't show any errors on the board either. would this fix it? Thank you
I just had this problem fixed. There is a sensor that has a lever arm on the suspension that was jammed in one position (they said it was like a knee that was hyper extended). Once they un-jammed it the headlights began working normally.
My adaptive malfunction light came on, my wife took the car to the car wash and about 3 hours later, smoke came from the dash and now no lights work whatsoever!!! Not even the brake lights!!! Helpppppppppppp
i believe it has to be reset, because i put new headlights and still having the same issue. one of my xenon headlights goes off at times when driving. have to turn off the light switch on and off 4o sometimes make it light up.
I mess around with using a screwdriver to try to loosen what looked like a clip holding it and it just pulled out. The second one just I could just straight forward pull out.
I recently add an Android radio to my Mitsubishi lancer. After about 2 months my battery started getting drained. There is a fuse that is pulling two amps when the car is off and it is the radio fuse. Do you know how to fix this problem
I have installed same display from Auto electrical shop . But I have issue with time on my display. when it's connected with hotspot time will be automatically update but when I stop my car and if there's no internet time is changing with the date. How to correct this issues? Do you have any idea?
When u do a video do it the right way , all that damn time laps crap with crappy music.. u did not go through the wiring steps . SMH 11 mins wasted of my life
Sorry? It was a plug and play kit so we didn’t think go through the trouble of getting all the shots of connectors. Our kit and car lined up perfect that it was just snapping in connectors. I’m seeing a lot of problems with the quality of these units. Overall I wouldn’t recommend, get a name brand unit these android units slow down and become unusable.
