Hi Jay here Welcome to my RU-vid Channel! ╔═╦╗╔╦╗╔═╦═╦╦╦╦╗╔═╗ ║╚╣║║║╚╣╚╣╔╣╔╣║╚╣═╣ ╠╗║╚╝║║╠╗║╚╣║║║║║═╣ ╚═╩══╩═╩═╩═╩╝╚╩═╩═╝ Hit that bell icon for updates :D Thanks for dropping by,
Probably a long shot but I built my all together and for some reason I can’t pedal, I can with an extreme amount of force but if you push it by hand the chain tights and the wheel locks any suggestions on what could be wrong? And can it still be used as a normal bike?
I've recently obtained one of these lawnmowers, I've been highly delighted with the performance of this fantastic lawnmower, I agree with the gentleman in the Video, it's a fantastic lawnmower, would highly recommend it
Wondering if there’s some more expensive product out there that can detect small gold bits hoping to find that soon. Thanks for demonstrating this. I have the same one and noticed it didn’t take my gold earring and needed to confirm that thanks man!
Thanks for the video .. The only problem I see with your setup is by using the provided spacer plate and modified to fit over the the shoulder on the slide ... is that the wedges are not locking the whole length of the dovetail in the tool holder if the tool is as low as it is in your video - Better to machine away the shoulder and use no spacer if you are not going back to the original setup - there is still 6mm tapped material on the slide which is enough
Excellent job! I made almost the exact same thing. The only differences are the plain ball bearings are pressed into an aluminum housing and the collet chuck shaft moves fore and aft in the bearings (don't have to do 2 things at once).
Probably a stupid question but how did you align the mounting points on the bench? When I try to align it at the edge, I cannot get the inner jaw past the bench edge.
Thanks for the upload, great job on the build! 👍 I'll be doing one of these kits in the very near future and have watched numerous videos on how to do it properly. Your vid is one of the few suggesting greasing the clutch mechanism and using the self tapping screws on the tank and tensioner. Im guessing the folks who haven't taken those steps are the ones who have issues and leave the negative feedback. 🤔🙄 How's the engine been holding up for you, still working good after a couple of years? Pete (watching from Canada!) 🇨🇦
You are the reason why I got my bike together and kept my sanity. What are the odds that the first thing that I typed in RU-vid led me to your video with your exact motor(except for a couple of minor things)?