I have a 2012 F50 and sad to say, this is the LAST POS Ford, I will EVER own. "Service Advance Trac" light came on so I scheduled repair at the local dealership. 4 trips and $2200.00 later, it still comes on. (after backing out of parking stall, mostly) changed steering link, engine module, front end module and still, can't find the problem. Beginnging to realize, why others call a Ford (FIX R REPAIR DAILY)
I lived between the middle school and high-school. I have to say that my block, or area for that matter, was hit hard. There are trees with v shapes at the top. It was a big deal that people dont talk about.
Thank you! Funny thing is all I had was the engine light so I went to my local AutoZone to pull up the code. They put in a new MAF Sensor and air filter. Car is running tons better. However! Now the AdvanceTrack light came on immediately about Five mins after I drove off! Might be this very issue! Thank you!!! ❤
Replaced electronic steering rack on 2013 Ford Taurus and got the Service Advancetrac msg. I believe a Ford programmer is necessary to fix. Prob need dealership. Can anyone comment?
Close, my light will come on, go off, beep, and when I apply brakes it pulls hard left with slight grind. I replaced all 4 brakes, and a frozen cal. Still happening. Hmm Dealers around here are all been known and reported as crooks.
Mine (2012 fusion) advanced light came on last week n would go off, then on my way home tonight I had a glowing left caliper. Gonna replace them both and pads n rotors. Did that help in your instance?
@@deancrothers5466 WOW, No, didn't help, I replace another cal in the rear. In my case, I'm starting to think its a voltage problem. The next good day, I will run a few voltage checks.
Street ride view showed pavement has good maintenance, nice housing. No projects for mass housing units. Also no private armies or prison. Saw no homeless camps, no faith- based execution sites, no chained workers, no aerosol paint tags. No unsupervised children obviously gone too feral or tribal. Police State clues (recording traffic in and out), was limited. Did I miss anything my reader thinks is important for visitor information purposes ? Me? I'm looking at a 31 hour dual sport motorcycle ride of 2,021 miles if I stop to see people in NM. Where I go off-road is my business but I purchased that ride extent for speleology interests.
I just started having an issue with my 2013 Explorer, I had the same type of issue with a Chevy Cruze when I parked it on the grass, dam squirrels ate thru a wire in the cruze, I SURE HOPE it's a similar issue
honestly i dont know off the top of my head but I do know it'll be A LOT cheaper if you buy it yourself online or at a parts store versus buying it through the dealership. fortunately for me, I didnt have to replace the whole harness, only a section was replaced.
@@cheizaguirre5494 I brought to dealer after it went into limp mode. The replaced MAF sensor and never got the Advancetrac light again... How they're related? Beats me these cars today can't sneeze without sharting their pants.
@@Ze0th i replaced my map sensor yesterday and then the light came on lol ..i hope it was just the connection or default part i put the old map sensor back on and light went away
@@cheizaguirre5494 yeah, no clue my friend. Ended up selling my Ford and got a new 2023 Jeep Rubicon because after the all trac light came on it never really drove right after that, the light never came back on but the trans seemed to be confused when and where to shift.
Good footage with audio, but the need for the space, new-age music is unnecessary. I live in Sand Springs and I had family that lived along HWY 51 where it went under. That area is prone to flooding, even when the river isn't up that high.
Appreciate it! I agree in reference to the music but the app I used to edit the video limited me to what I could use legally so what you hear is practically all that was offered (for free). I hope the property made it out OK! At the time of the flooding I was working for webco and we got shut down for a short bit of time water surround in the building but didnt actually touch it luckily.
Yeah I'm having the same problem with my 2017 Ford fusion hybrid. That and the hill start assist light keeps coming on. I guess I'll have to pop the hood and check it out, or probably see if I need new fuses too 🤦🏽♂️
I have a 2013 FX4 w/6.2 motor 135k miles (I bought it used in 2015). I started getting these same issues randomly about 9 months ago, I checked about a dozen possible causes all over the truck from the battery, ground wires, wheel sensors, fuses etc. The last "fix" I done 3 months ago (problem solved so far) was the brake control module located under the dash drivers side. I did not replace it, I simply secured it to the bracket it mounts to with two large wire ties. WHY? .. the brake module is secured to the bracket from the factory by a twist lock design (bad engineering), I noticed this module comes loose over time from vibration, bumpy roads, releasing the parking brake etc. (while driving your brake pedal is making constant contact with this sensor). I haven't spent any money on solving this issue or taken it to the dealership. I hope this helps someone.
When you said the repair was done without having to replace the entire wire harness was this done at an actual dealership? Pretty cool if so. I think I am in the same situation…now it’s off to find an ethical and transparent shop. Thanks for the video.
@@joseybmorgan3034 thank you for the feedback. I saw that you answered my question already in the description…i’m going to take heed and avoid dealer as you mentioned. Thank you
Hopefully this will be the same case for me, been messing around with the this thing for past few days ,4-8X for last two days. Always enda up as something dumb and simple to fix. Thx for the helpful video.
Hope it helps man thanks for the comment 😁. If you didn’t read the description already be sure to check it out I’ll give a little bit better description of what to check for
I have had this light "service advanced Traction Control" for about 3 years now it only effects my turn signals that I have seen meaning they wont stay on by themselves while warning is on. but other than that no other issues I have been told since i installed over size tires it caused this and have been told ( not sure how true it is ) hat the only way to solve would be resetting ECM and let it recognize the larger tires. I just got a OBD11 Scanner but as of now have not looked up yet how to do this.
It was throwing at least 3-4 codes. 1 was the throttle body. Another was mass airflow sensor. And there was a couple more I can’t remember. but keep in mind the burnt wires were throwing false codes so PLEASE start with looking over the entire engine bay for anything outta place (burnt, unplugged, missing, etc)
Wow mine happened after a little bump with another vehicle while was parked, then the advance traction came up all fuses are OK and the codes thrown are U0140:00-2A U0155:00-2A U267:00-2B Pls advise thx
Mine turned out to be the ABS hydraulic module. As you can not just buy the Hydraulic part (HCU) I had to change out the whole part (Electronic and hydraulic parts). Unbelievable and unbelievably expensive... Nice work Ford.
I believe 1 of them had to do with the throttle (throttle body or TPS) something to that nature. And 1 was something to do with the traction control system. I’m sorry I don’t remember what fuse numbers off the top of my head
I am having almost exact same problem with my 2013 Fusion, except it usually happens when i am making a sharp turn when backing up or turning into a drive way hasnt happen with straight driving and no noticeable loss of power. Your video was helpful since if wiring is lose or compromised in some way sharp turns may stretch it near the wheels, will check all that thanks
My 2012 F-150 does this same thing. I replicated today, 9/9/2022. It's only when I cut the wheel all the way to the left. I get a loud noise I can't even describe and the light comes on.
Whelp, that wire harness is not my problem. Wires are ran better on my truck, they don't even come close to the exhaust. I've got the 5.0, not sure what engine he has.
This just happened to me this morning. It was my battery fuse relay on the positive side it had burned out. Went to O'Reilly and got a new one and was unlocked and ready to go
Man i have been having this same exact issue on my Ford Fusion based on your description of it. I am praying thats all with mine also. About to check it out!
As far as the brakes go, if they're still working as they should it's probably a fuse. My abs and brake light both came on the day I took it to the shop but the brakes were working just fine
@@rickmossop3733 good possibility. When my issue first started I took it to Oreillys and used the code reader to clear the codes. Believe it or not, it would drive normal immediately after clearing but that only lasted about 1-2 minutes until the computer cycled or whatever