Will this switch being faulty be the reason why my Kia Ceed is stuck in park and won’t go into gear. The engine won’t start either. I can force it into neutral and only then the engine starts!!
I have a 1991 Chrysler imperial and I had a lot of smoke come from my wheel bearing and its clunking I have a part coming in two days then I'm doing a full relubrcation of the front and rear wheel bearings, anything else I should look for?
na tuhle závadu jsou v manuále tyhle možnosti : Katylyzator, Horní Lambda sonda nebo jednotka ECU. Nicméně bych se mrknul v diagnostice v grafu jak fungují po zahřátí Lambda sondy (spodní Lambda nesmí kopírovat horní), dále tlak paliva a komprese motoru, tím bych začal
@@amhet1 tak a auto je KO neštartuje ... rozvody su zničené ... po 2 rokov po vymene v aut.servise ... a cena 1500 eur s pracou .. kat.bol nový aj obe lambda sondy .. ďakujem za odpoveď...👏👍
Thanks for this. Well presented. I prefer not to remove the battery or computer as you can access the 2 air box bolts with an extension and it lifts out OK. The 3 bolts holding the the fuel filter bracket to the sidewall can be accessed by undoing the securing bolts and moving the computer loom to the side. I use 6mm rubber chair tips to block the fuel line ends. I also refill the new filter with clean diesel (about 250 to 300ml) before re-install to avoid any air lock in the fuel line. Takes about 4 to 5 seconds for the car to start after. Filter part # 31922 A9000 also fits my 3/2014 build.
Can you tell me more about how to prime the fuel filter and remove air? I have a 2020 hyundai santa fe and I can't find hardly anything online about how to change the diesel fuel filter and properly prime it to bleed out any air. Do you need a OBD2 scanner to do so?
boa noite, o meu i30 1.6 crdi de 2008 teve uma avaria no imobilizador da chave, a lâmpada indicadora da avaria ficou acesa 72 horas e desapareceu. Nunca mais apareceu. Será que queimou, ou é algum fusível ese queimou, como a substituo. Obrigado. Carlos Correia
Having problems with the immobiliser light coming on and engine cutting out. Swap the immobiliser for a new one, car started, but after 10 mins had the same problem again. I wonder if anyone has any other ideas.