People might want to try a 1k resistor before they try a 470 ohm. See what you think of 1k as the LED's could last much longer if you find them bright enough.
The blue LEDs that I used are a lower value than the original resistors. The brightness would be too much and can cause them to burn out. You can experiment without the resistor and see if it suits your taste.
Really nice simple to the point explanation on getting this job done. RU-vid also needs a new video for the Pitch and pop up light. Maybe you can one for those as well.
Hi really nice video :) very well explained i have one question please i want to replace the strobe leds into blue and also 33 and 45 buttons what kind of resistance do i have to use? thanx.
Thank you, I use a 470 ohm resistor for the strobe leds. I haven't replaced the 33/45 leds yet but I know there are videos out there that may mention the resistor they are using.
I am in tears watching your beautiful video for your beautiful mama Nida. Please tell her Rosie from work (Dona Matutina) says hello and that I want to get back in contact with her. Not on FB anymore but will have my sister in law reach out to her via FB for phone numbers ok. Happy Birthday beautiful Nida ❤
@@lyndondancel9400 Hi Lyndon. I somehow never saw your reply until just now (2 years later). I will email you my number tomorrow since it's a little late. I was thinking of your mom and decided to search for your video on RU-vid and found your reply.
