Nice diacritics man!!! did same dial I dint have continually, on the cord or the switch, I got bad brushes I have no idea 🤷🏻♂️ where to get some any ideas 💡?? Thanks
Nice, to the point useful diagnostic testing method. Thanks Am I to assume that if I have continuity to the brushes, it's definitely the brushes? The shaft spins freely by hand but my brushes also look like they have plenty of life. When I removed the shaft the brushes pushed in about a cm on both sides.
There's a possibility that it could be the armature but brushes are so cheap it's worth getting a set to throw in and try out. Do the brush springs have decent tension and do the brushes move freely in their holders?
I got this machine a week or so ago thinking I would be able to adjust the pulse parameters. I couldn't find anything on adjusting it. It pulses way to fast. Have you played with the pulsing? And have you found a way to adjust the pulses per second?
@@lunchboxproductions1183 pulse rate gives you different weld appearance. Fast is close puddles more mig like appearance. Slow pulse rate is more tig like and less heat absorption. I had a 352 mpa and I could make the welds look identical to a tig weld.
I do intend to make a video using the machine, with .035 hardwire (short circuit and pulsed spray) and .045 dual shield. I've been waiting on getting a bottle of 90/10 to try out the machine's pulse settings so that's been the hangup. I'll probably do a short circuit MIG/ dual shield video and save the pulsed spray for another video when I get some 90/10.