Hello friend, how do I set the pressure sensor of that model? When I fill my rifle, the pressure on the rifle reads 200 bars and the compressor reads over 1000 bars.
please answer me do you still have this machine it turned out good for you which is a good brand of such machines I got a similar one tuxing 031and it broke
great video.....these valves are usually the problem when pressure will only go to about 500psi....2 things to add....the top valve in the cylinder head is free to rotate with vibration...so fails to shut off, that was my problem.....so on reassembly instead of silicon oil i used a spot of loctite to stop rotation.....also the second valve you show us should be seated in the top off the cylinder where there are recesses for it, i have not found this one to rotate so just popped it in and rotated to correct alignment
Sir, i have the 3 buttons model and i have the problem that isnt showing the working pressure , only the set pressure. Could you give me a hand, there is absolutly nothing abouty this type of display
wow very good pumps, how i wish to have one someday... cant afford to buy yet. sir, do you have give aways? i also like your videos how to operate electric pump. more power to your channel..
I got one of those. The tank connector tube blew at 2500 psi after 10 minutes of use. Fixing that one it took another 30 seconds to blow the second stage head. Complete crap
Hope all is well. It seems I can’t find much help troubleshooting my Yong heng. It had served me well for 2 years , but unfortunately it had failed me today. I have no idea where to start or what to replace. Both air chambers are holding pressure, but it just won’t go past 1500psi ( I usually fill my 100cu 4500 guppy tank , all the way to 4500. Never had a problem until today ) I do notice of a crank close the release valve (with a bit of force from a wrench) on the second chamber it will climb to 2000psi but if I hang tighten it will fall back to 1500psi and just float there running. I don’t know what to do. I can’t fill my tank anymore. Any help would be appreciated. I’m prepared to take apart, but I have no idea what to replace or look for , like I said.
Hope all is well. It seems I can’t find much help troubleshooting my Yong heng. It had served me well for 2 years , but unfortunately it had failed me today. I have no idea where to start or what to replace. Both air chambers are holding pressure, but it just won’t go past 1500psi ( I usually fill my 100cu 4500 guppy tank , all the way to 4500. Never had a problem until today ) I do notice of a crank close the release valve (with a bit of force from a wrench) on the second chamber it will climb to 2000psi but if I hang tighten it will fall back to 1500psi and just float there running. I don’t know what to do. I can’t fill my tank anymore. Any help would be appreciated. I’m prepared to take apart, but I have no idea what to replace or look for , like I said.