I have been tinting vehicles, home and offices for 29 years. I also work in the car audio field. i also work part time on cars, small repairs, some electronic repairs,etc. I love to make how to videos in my spare time to help out do it your selfer's. I have been around cars for over 35 years and love to work on them. I have a small window tinting and car audio business in San Diego California. I own, manage and work mostly by myself and have been doing so for 29years.
You can definitely get it from the top and is much easier to replace from above with an extension. Then trying to remove in a tight space from underneath
Great tip take pin out of brake pedal The brake pedal drops down just enough to get the rubber stops in now both cruise control, and the brake lights work again I got the part at AutoZone and there were two grommets and I was fortunate enough that they were the right ones to go in both holes. Thank you so much been fixing cars since I was 14 I had a body shop at 18 I fixed wrecked cars did insurance work saved people their deductible. I’m 71 now
What do you do when your EGR valve is stuck to the pipe it screwed to and when you turn it it just wants to twist the whole pipe instead of breaking loose even after torch heat on the nut.
@@JeffMitchell365 i believe it goes into the upper intake. The nut has to be heated. If you can’t get that nut off the intake, you will have to replace the upper intake complete. Thats sucks
Ditto all the positive comments- thanks! Any tips on how to change my hood hinge? The “ball joints” are pressed into the hinge, and somehow I lost those ball joints. Now, I need to buy the hinge to replace and it looks complicated (taking off the fender, etc)
I didn’t get notifications and calling alerts when wrist detection is on If I do off wrist detection then all things work fine Why it is And I did all these things but didn’t get solution
my watch sometime acts weird and i can't even change the settings. i usually let it die, charge it back up and everything starts to work. also make sure your watch is not in theater mode. obviously some fixes don't fix everyone's issue, especially if the watch is old and acting weird like mines. i have turned off my wrist detection and it still acts like its on. if you have the setting raise to wake up on , then it will still detect your wrist. not always does one setting completely stop a function on these apple device. sorry it didn't help you out. i am not a tech. i just stumbled on to this on my own, by trial an error. but i also didn't realize that my phone could have been in theater mode. SMH !!
Thank you Mazda dealer left the small soeaker unplugged with cable dangling behind the door The also managed to scratch the inside of the door opening it Fixed it with your video 🙏
Hey there, I was replacing my control arms and while I was wrestling the control arm out I think I accidentally dislocated my driveshaft. What are some ways to tell if I did or not, and if I did how would I go about getting it back in? The boot is still intact
@@nikomunoz5167 if you try to spin the drive shaft, it should not spin freely. If it spins real easily then the axle probably popped off the transmission. You can usually try to pop it back in. Make sure it goes in the gears, then slowly tap it with a small sledgehammer. You might want to look carefully where it goes in to make sure it popped out.
Do you think that the ready set of speakers from the Mazda 3 BK will fit the Mazda 3 BL? because most of the sets are for BK, and it seems to me that the screw holes are identical, but I'm not 100% sure
@@karolpiechowski5380 they may fit, but if those are some sort of upgraded speaker, or premium speaker, i would not put them in. They usually run off of a factory upgraded amplifier that probably crosses over the frequencies. So its not the same type of full range speaker.
@@ismaelpereda6639 my neutral safety switch ended up going out later. I think that was why this was blowing fuses. I had to replace it. The wiring had partially melted. I have a video on how to replace that also.
@@s0meGuyMarlyMar could be just the filament that is sometimes touching. Bulb needs replacement. I listed the LED bulb i used. I listed the bulb type. Doesn’t have to be the same bulb i used, just same type
Thanks for this video. I had no air coming out of the vents when driving or parked. It was a bad solenoid. I replaced the solenoid and everything works as it should! 1998 Volvo S90 245,000 miles and everything still works! Runs and drives better than most cars with a 100,000 miles. These cars are built well!!
What you heard rattling was very likely the individual ball bearings from the bearing in the distributor. When they come apart, it allows the cam sensor signal plate to wobble as well as play up and down which actually can bend the thin metal signal plate if it contacts the pickup for it, setting the P1336 crank sensor cog damage dtc, and of course the ecm doesn't know when to open the injectors or fire the coil which is the stumble we feel.
@@arman757 were you responding to someone who commented? Or were you mentioning this to me? My distributor is brand new. My crankshaft sensor failed twice ( shitty autozone parts). Ended up getting one at nissan. No more issues. Costed way more!!’ Alot more
Does anyone know where I can buy a replacement for this specific door handle? My current door handle is peeling and I want to replace it, but I can’t find the part anywhere 😢
My dog scratched up the top leather portion of the door panel, does the entire door panel need to be replaced or is can that piece be disassembled from the panel?
Excellent video! Get the silicon grommets off Amazon and you dont have to pull out the pin. Just push the brake pedal with your hand and use the other to push them in place. I agree to let off the brake pedal to sit them in properly. Took me 5 minutes with this video and a flashlight.
I watched the whole video and you did a great job. Unfortunately the driver side door won’t open from the inside or the outside so the panel can’t be removed. Any trick on how to get the door open? Thank you
You would have to remove the front seats from the opposite door, so you can have room to remove the door panel. Once the panel is off , you would have to see why it is not opening
I wonder what took me so long to watch this video. That bulb burnt so long ago in my car and I didn’t know the number of the bulb so I could change it lol. Thank you !
