I’m just about to do this, but with a thicker section of wood and the jack stands closer together to reduce the pressure. I’m changing the rear shock on CRF 300 so fingers crossed 🤞 it all works. Great idea though…just what I was looking for. 👏👏
If you have a wattage limiter you most likely have a remote to turn on the fan and lights - if your lights seem like they’re haunted try holding down the light on button for 3 seconds to control the voltage to the lights
I Also have a 2007 Tucson 2.7 v6, with 150k miles. As a DIY garage mechanic, I found your video very helpful. If you’re removing the intake manifold, I do recommend not skimping on spark plugs. Quality is your best friend. Since you have removed the intake manifold, I would also recommend replacing the valve cover gaskets. I’m so happy I did. I found a small oil leak coming from the back valve cover gasket around cylinder 3. The gaskets were also brittle and broke very easily. I also replaced all spark plugs cables. I also noticed that the wiring harness casing was brittle and crumbled in my hand. I used black electrical tape and small black zip ties on each end to secure the tape. If done properly it looks great and will last a long time. BE GENTLE! while taping the wire harness. You break a wire, you just created more work for yourself.
Not a dumb question. Marking the blade is a great technique. If the wiring is attached to studs and you measure correctly you should be able to avoid the wiring.
If doing this from the outside after removing vinyl siding, is it difficult to find the studs/cavities to fill them? My nightmare is I pull the siding off and can't figure out where the cavities are to drill holes and fill them from outside. Doing this from inside would be extremely difficult as we live in my house.
Is it possible to do this while the resident and all his (my) furniture is still there? I have an apartment in a co-op, and I want to do this for the purposes of sound isolation. My living room wall is fine, but I hear every word said on the other side of the bedroom wall. Possible to just wrap furniture in plastic, plastic off the doorway, and do this job?
Yep , cover it , finish the job, patch holes repaint and clean, uncover, reclean dust, uses floor drop sheets , hang a drop sheet curtain over bed room door, and keep closed to isolate dust from spreading to other areas , block the floor vents, remove window screens, then you can help push dust outside with a box fan, use a shop vac with dust bags,, I'm a retired pro, your welcome
Thank you so much for this video. I brought a older home last year that was made with stucco walls. It is freezing in the winter. Not a drop of insulation 😳😳😳 I'm going to try this. I will definitely report back how my electric bill is 😃 afterwards!!!!
You don’t need to remove the side of the intake manifold. Just remove the other bolts and screws and the whole manifold will come out without any issues
Perfeito! Até que enfim achei um video de alguém que tivesse feito essa manutenção numa Tucson. Os demais videos são na Santa Fé, onde o coletor é diferente. Perfeito, perfeito, perfeito... logo mais irei trocar eu mesmo, as velas da minha V6.