Концепция интересная, выехать людей удивить, да. Но ездить на таком сомнительное удовольствие, посадка- тело наклоненное вперёд ладно, но упираться при этом на ручки согнутые вниз очень сомнительное удовольствие. 🤔🤔🤔 выставочный экспонат 👍👍👍 . Работа👍👍👍
Nice video 📷, what was the mixing ratio of epoxy resin & hardener? Can be added glow mica powder in the rein solution, it will give a beautiful glowing effect to the knob at night
Howdie from CANADA 🍁 SK glad l found ya coooool build keep it up some people need to chill until they make one like this sit bk and enjoy the great work of this is enjoyable to see don't have to have a degree or rocket science test to make this so glad for ya sharing your project with us good luck 🤞 😊
Everything looks great. I would recommend to reinforce the wheel pivot-to-fork tube joint with a partial radius via tubular sleeve to diffuse lateral forces on the butted-weld sheer line. The weld looks decent, fusion is probably not an issue but it looks like you didn't wrap the welds/tie-in all the way around the tab and that gap is a potential failure point where vibration/ and directional torsion/side -loading/compression can occur and generate a crack in the weld. Hope this message finds you well.
