what if you just have to time the front cylinder ? timing chain snapped on front cylinder and i was wondering if you can go 270 degrees from back cylinder to the front one for timing too?
Hey how much oil is required.. plus no one has shown how to do oil change on the 1000 prowler its not that easy how do you get to the oil dip stick i can't even reach with my hand to check the oil lol Thanks for any help. Mark
I followed your instructions to replace a CV Boot on the passenger side front of my 2012 Arctic Cat 700 Mud Pro H1. I got that done, but when I went to test it, my ATV now has a clunk in it towards the back when I shift from Reverse to H or L. There's two things I did that might or might not play a part. While I had it jacked up I shifted it out of 4X4 so I could rotate the axle hub. The second thing was I rolled the bike ahead while it was in N and on the floor jack. Any ideas appreciated. Thx.
Question. Does anyone know how to properly install and aligne the cams for a 2007 Yamaha Vector ER? And which cam is which. He speaks of single ring and a double ring, mine only have single rings.
my 06 Vinson is the same, have you found a solution.. I managed- after considerable swearing and effort to coax my belt back on but sheeeee-it there has to be a better way! cheers from Kenora Ontario
thanks a lot, I bout a 650 for a couple grand and the linkage is kinda odd but it shifts it just sometimes is a pain in the ass but does work btw is there other fluid as in trans axle yadda yadda yup its my first one and i have rebuilt car engines & transmissions so this cant be that hard i hope lol
So... If I've removed all the shims and it's still out of specs, what do I do? My clutch is running hot on a 2018 thundercat. It's supposed to be 62.5mm from back of drive clutch to front of driven clutch according to someone at hardcore sledder forum. With no shims I'm at 64mm.
Outboard CV joint removal...a few taps and yours popped right off. Mine won't budge, it looks just like yours. I went from light taps to hard smacks...won't even try to budge.
It's a pain. Hit from one side and switch to the other is what I did. After 5 minutes it finally popped off. There's a little ring inside holding it in place.
@@ryanmassengale5652 I spun it around and beat on it with and without a ling brass dowel. I didn't see the point of trying penetrating oil considering it is packed with grease. In the end I removed the other end.
