I watched video to figure out how to make two 32 mm motors to work with a 5 channel remote. The issue I am facing is that each motor only runs for a few seconds on each direction. But I need it to run enough time to up and down for a 90” tall shade. It seems that I need to reset and reprogram. But don’t know how. Any advice.
Thanks so much for this! I motorized all my shades at our other home that had existing non-motorized corded roller shades when we bought it. Now deciding how to approach the same process from scratch in a second home we just bought. I purchased one corded roller shade so far and since it came with a valence and end cap attached that left me stymied until finding your video.
Binthen provide motorized curtain in standard DIY package kit, much easy than tradtioanl way to distribute and sell it, ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-i-YcC05ZdhI.html
1st... Thanks. Appears to be a simple swap. But you didn't say how these motors are powered. Do you need to dissemble them every time you need to replace a battery? Or do they hook up to a 12V, 110V or solar power source? Maybe the part number of the motorized unit would help. We are building a new house and I am just now exploring the possibility of 12V units, do not want to use 110V... that's getting into a whole new mess there. 12V wires can be run in a wall without adhering to local electrical codes. Again thanks for the video!
Hey, Will this motor work with wider(5 feet wide) blind, as my blind is wider than this motor. Does a blind must need a motor which fits the housing or starts from 1 end and must reach the another end of the blind. Thanks
No, the motor does not need to extend the full length of the blind. Description on Amazon website recommends the following Maximum shade size: Width 98 inch Length 236 inch, Max weight: 7.7Lbs,
Very helpful for this smarthome newbee. I already bought four roller shades but do not know the diameter yet. Will measure them once delivered and then order the right Zemismart motors. Thanks for your clear installation instructions.
I hope 🤞 this comment reaches you.🧐🤔 would love to know if you can control 4 to a remote? How many channels and multiple motors can you have? Would love to implement that into my new home theater design? Let me know.🤔🧐👍🏼🤞😎Thanks.
My blinds are not Hunter Douglas but are similar to the Hunter Douglas Silhouette. If the interior of your roller tube has a similar profile and you order the proper size, you should not have any issues with the installation and operation.
I think this has now sorted out the problem I was having. However, one thing you didn't mention was that your camera needed to be set to manual. It doesn't allow you to do this in auto. I will try tomorrow, fingers crossed.
It's confusing that it stays 50 @ F 3.5 yet the exposure changes at the beginning. This camera has never made any sense to me in video mode.. Changing iso while shooting doesn't seem to change anything in the video even though it appears to while filming...