@@SebastianInt sounds good would like to see how it goes plannin on the same for mine ... kinda want to upgrade my sidewinder to a sheepey as well first
Man ! Your car is nasty !! How much did this build cost … if you don’t mind I’m planning to get a GTR soon and I’m trying to see the price on how much it would be to make this kinda power
Thank you! It’s my uncle’s car. With a fully built motor and upgraded turbos, you’re looking at 30K+ which is around what he spent. You can make the same power with a stock motor and trans as well. It just all depends on how far you want to go with the build.
Thank you Junior! And I think you’ll have to run a spacer with the +35 offset because I read that a 17x9 +22 RPF1 clears by only a couple millimeters with TL-S Brembos.
Tried doing this but was so damn hard to push through the fiber optic line through the fabric on the other end even after using a thicker needle ! Any suggestions? Thanks!
I had the same problem with a few cars that have thick padding on the headliner. I just went back and shoved the needle farther down to create a slightly bigger hole. Play with the insertion angles too. They can be bit tricky to feed through sometimes because of the angles that you poked the holes at.