Thanks for sharing! I’m currently using XCS but was looking for more advanced settings for metals like crosshatch fill etc. Maybe you know, does F1 support it in lightburn or not?
Hi I cannot get light burn to work with my F1 When it frames its up in the top left corner and about the size of a pee it also runs the program up there any suggestions I am running version 1.4 .05 in Lightburn
If you check the description field for this video, there will be a link to our blog post where we put all the settings including the time taken for each project.
I haven't read many comments. It wouldn't work for me until I ungrouped the image, then right click and apply mask. Final location, right click - flatten mask.
Good question. It would be something I would have to test. I did notice next to the Optimization Settings - Remove Overlapping Lines there is a drop-down that may have something to do with this but again it's something that needs testing. So I'm not much help I'm afraid.
Totally useless 🤬🤬 I wish someone on RU-vid could show how to use that machine to a beginner, how to set up the software and use it instead showing just the results 👎👎👎👎👎👎👎👎👎👎
This was never meant to be a tutorial on how to use the machine. It is a review and demo, so it’s pretty sad that you chose to downvote us just because you didn’t get the information you wanted.
Has this been happening since you got the machine or is it something new? It sounds like a connection issue. Or it could be that the laser lens is dirty.
@@golasergo I actually used it twice and the second time my laptop stop working 😢 because the power supply took to much power that's what they told me
We haven’t tried cutting acrylic with it. It should cut it but I couldn’t guarantee that. It might be best to contact Sculpfun directly to get a definitive answer.
