Hello.i have the same engine and i change oil in 9.500 km in one year..Its ok???because some friends change in 7500 km and i think this is very early from synthetic oil.Thanks
Hi there @radulepg yes warming up the engine will help the loosening of the glow plugs. Just bear in mind that the engine will be hot so be sure to have some pliers in hand and some gloves to protect your skin .
What a shame the designers didn't think to have the connector accessed via the bolt hole, BAD FORD, I'm struggling to get the cap off to change the colour on my used one.
When you pulled out the damaged mirror you should have attached a string/wire to the original wiring and then attached the string/wire to the new mirror and just pull it through.
Where did you get the final harness? I have bought a 2 din screen and I have iso adapter but not the final one and can’t find. Thank you very much, regards
Hi, just replaced my fiesta’s door mirror like yours. Works perfectly with the controls on the door to fold mirrors and adjust the mirror. However, the mirrors will non longer fold close or open when using the car key fob. Any guidance on this please? Do I need to re-sync or do something to get the key fob to fold the mirrors in and out like they did before??
Should be loosening the negative terminal first when taking out the battery and the reverse when putting it back in. i.e. Removing battery: negative then positive. Installing: positive then negative. If you do not do this then you risk the spanner contacting earth when you are messing with the positive while the negative is connected, then you'll see some sparks fly or worse. This is relevant for all cars.
So how do you manage to not cross thread the airbox screws when you use an electric wrench? Oh, you don't. So you don't give a damn whether or not you cross thread them? I see.
Thank you very much @RealA-Vlogs it means a lot, everything we do here on this channel is from the goodness of our hearts, we do what we can to make others laugh and to help you guys with your cars.
before you put the cable through the top hole when installing the mirror, make sure you attach a long wire to it. then run the wire down until it comes out of the bottom hole with the plug, then tighten the mirror (13 hex flange nut in case it gets lost). i had tried this without the wire, installed it and the window regulator pushed the cable down. be sure to use the wire, i spent hours trying to figure out why the cable was interfering and pushing it to the side etc. apparently there are several shafts in there, hence the problem with the cable blockage. bevor man beim einbau des spiegels durch die obere öffnung das kabel steckt, unbedingt einen langen draht daran befestigen. dann den draht runterführen bis er aus dem unteren loch rauskommt mit dem stecker, dann den spiegel festmachen (13er sechskant flanschmutter falls diese verloren geht). ich hatte das ohne draht probiert, eingebaut und der fensterheber hat das kabel runtergedrückt. unbedingt mit dem draht machen, ich habe stunden damit verbracht warum das kabel stört und zur seite gedrückt etc. anscheinend sind dort drinne mehrere schächte, daher das problem mit der kabelblockade.
