Top Blade Center, the teeth are placed at the center, you do not center the fullness of the blade, go here for correct prodedure, www.youtube.com/@bandsawlife2660 YOU copied the wrong YT video!!
You do have to spend some time setting the saw up... blade, fence, etc. But once done, the saw is great. Fairly compact which is Nice ru-vid.comUgkxXh-4_3-ZT1fFWP91ZV7iVqzElr0lEb-a I did get an Incra Miter Gauge which takes some setup as well. The stock miter gauge can be adjusted in the miter slot with a little painter's tape... this tightens up the side to side play a lot.
Thank you so much for this informative video. I just purchased an entry level table saw and the instructions were less than clear. Your video really helped me make sure my riving knife was properly aligned.
I have a question I have a kobalt Table saw and the knob below the riving life has been missing for a long time what do you know where I can get a new knob or if I just tighten it up with the set screws arrive and I will be fine
Each time I tighten my bolts down the knife moves am I being to aggressive ? I just fear that the dam thing will come loose during cutting, please advice!