Распаковка лобзикового станка Ferm FFZ-400N (б/у) и его первый пуск. Пробный распил штатной пилкой тонкого ДВП (2 мм), OSB (10 мм) и доска 20 мм. сосновая.
Hi After 2 years I finally got around to move the tensioning knob to the top. First I took off the two side covers. I then used a small drill bit to knock out the retaining pin so I can remove the tension knob. I removed the sprung panel at the bottom. I then carefully marked and drilled a hole on the top of the machine above the tensioning threaded rod just large enough to allow the removal of the rod which I removed also removing the metal wedges the rod travels through one only is threaded. I turned the rod upside down and replaced it from the bottom. I had to swap the wedges over to match the threaded section. I was then able to replace the knob at the top. It works fine however the knob now vibrates when in use. Does yours vibrate. Thanks for the idea Igor kind regards. John North East England.
А что именно модернизировали? Единственное, что я в нем изменил - перенес ручку натяжения пилки наверх. Хочу еще изменить узел крепления пилки и знаю даже как, но все никак не соберусь.
У меня натяжение пилки спереди. 1. Отказался от штырьковых пилок, переделал крепление пилок.2.Перенёс кнопку вкл/выкл на верх лобзика.3.Убрал все защитные перегородки-кожуха из под столика лобзика ( в результате он стал работать ещё тише
я как-то зимой вырезал маме подставку под горячее, там был сложный узор, много, очень много раз пришлось переносить пилку в другой контур. штифтовые пилки - это зло)))
Hello Igor. I have just bought second hand this scroll saw. Can you tell me how you converted the tension screw from the bottom to the top please. I think it will be a lot easier on top, Thank you.
Oh... I made this improvement a very long time ago. Because the back is tired of bending to pull the saw. It really was very uncomfortable. Especially with a lot of repetition when cutting out complex patterns. I made this improvement a very long time ago. Because the back is tired of bending to pull the saw. It really was very uncomfortable. Especially with a lot of repetition when cutting out complex patterns. Nothing difficult, I'll try to help. There is an instruction with the schemes, I'll try to translate for you.
