but how can you pour the casting agent there? I think this mold is made wrong. You need to do the bottom part (where the little + on the keys are with walls to be able to put those down and pour from the top.
You pour resin into the bigger part of the mold, then place the top part of the mold (as you described with the "little +") the excess resin will squeeze out of the mold, you could also put water into a mold like this to measure the volume. It would be very difficult to mold it in the way you described as the underside of the keycap needs to be perfect if you plan to actually use the keycap
Apa itu cairan biru? Dan bahan apa yang Anda gunakan silikon sebelum melanjutkan ke langkah berikutnya ? english: What is blue liquid? And what material you scanned in silicone before moving on to the next step ? thank you
the blue liquid is Silicone Rubber, and what i apply before moving on to the next step is Easy Release. you can use easy release to make easier on unmold step
@@pibifactory1726 kok saya pakai rtv 48 mold nya terlalu lengket ya tekstur nya setelah di campur katalis, saya pakai katalis cuma 3% dari rubber nya, sehingga susah buat cetak stem keycaps nya, jadi susah untuk cetak objek yang sulit om macam stem keycaps nya itu.
@@pibifactory1726 pas bikin cetakan kedua saya udah pakai easy release tapi mold nya menyatu, dan buka nya susah Di menit 2:40 itu bang, punya saya malah menyatu, padahal udah pakai easy release sama kaya abang
