# 03 MyPlasm CNC Step by step EN - How to connect a plasma source

Подписаться 1,7 тыс.

Просмотров 28 тыс.

50% 1

POLSKA WERSJA : • #03 MyPlasm CNC tutori...
The next episode of a tutorial videos - MyPlasm CNC System step by step.
In episode # 03 I show how to connect a plasma source
Link to download the official version of the software:
www.proma-elek...

Опубликовано:

16 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 6

@williamdyson2205 Год назад

Hello. Thank you for making this video. I found it to be very useful. I am especially impressed with the 3D model of the wiring and comports near time mark 3:00. Is the software used to do a 3D model of cabinet and wiring also available?

@TylerHarney Год назад

So if my manual says "Arc Voltage Output" 1:1 ratio then that would mean It needs to be hooked up as ARC RAW?

@TylerHarney Год назад

BTW I have a "Lotos Supreme LTP5500DCNC" Plasma Cutter

@gladeamatoren7106 2 года назад

I forgot to connect the materialclamp😣The system doesnt read the arc voltage anymore even if I reconnect the clamp. Is the interface broken because of that?

@myplasmcncsystemen1506 2 года назад

Not connected Material Clamp id very dangerous for all of electronics. Contact me by WhatsApp ±48 604 247 648

@thomasgeldmacher1771 2 года назад

Hi there, I'm using an older model Hypertherm powermax 1000 G3 series power pack and I'm a bit confused about how and where to connect an arc good signal. Thanks