10 minute per Benchy on IDEX.

Подписаться 483

50% 1

In response to • Half your benchy time ...
I could refine this a bit more, but this is all I feel like doing for now.
Not an entry, but speedboatrace rules were followed. The silver ABS has some silk like properties, so it may not qualify. But again, this is not an entry.
Leaving comments enabled for now, but not looking to discussing settings because they could always be better with more time and testing.

Опубликовано:

1 окт 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 5

@caramelzappa 9 месяцев назад

The way to "enter" with idex is to split the model down the middle and lay each face on the build plate, in mirror mode. That way each toolhead prints half the benchy, and you cut your # of layers (and thus # of perimiters) in about half.

@rembrantsworkshop 9 месяцев назад

This fills me with joy, I will have to make a new video with the dragon burner tool heads installed.

@jerkyfpv2874 5 месяцев назад

What slicer are you using and can I please see your slicer gcodes for start/stop and filament change? Printer.cfg would be nice to compare to also but mine a Cartesian so idk how relevant

@Sfernan888 9 месяцев назад

How did you account for the nozzle offset in x, y, and z of the tool heads?

@badmouth75 9 месяцев назад

For mirror and copy modes x/y offsets don't matter. I was lucky that my z offset is small enough to not matter for these modes. For dual material prints I apply a gcode offset as part of the tool change macro (T1/T0). T0 macro applies offsets of zero (to clear gcode offsets) and T1 applies offsets of zero (to clear offsets so they don't stack up if T1 macro is run multiple times), then applies the actual offsets which I am still getting from test prints. Hopefully we'll get to the point of automatic offset calibration before every print, but there is still a long way to get there. The software side of that is beyond my sklillset. Hopefully I can get back into testing other people's solutions soon.