11 - Sparkie The Eel - Tips and Troubleshooting

Подписаться 5 тыс.

50% 1

In this video I’m installing a Delco EST ignition system on a freshly built Mercruiser 4.3 engine. This is a pre-Vortec (before 1996) engine so I have to custom calculate the timing setting since the timing curve in the module is for a Vortec engine.

Опубликовано:

28 апр 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 4

@moccasinmarine 2 месяца назад

One other tip. If your engine suddenly dies or sputters on the water, pull the shift kill harness out of the distributor. The shift kill switch may have malfunctioned and stalled the engine.

@acalinoob4534 2 месяца назад

Hello, I’ve been trying to install a kill switch to my 1987 sea ray and i nearly burned my starter down. Any advice to what wire to connect it too.

@moccasinmarine 2 месяца назад

The kill switch goes in the purple ignition wire from the run position of the ignition switch. It doesn’t go in the start wire which is sounds like you’ve been doing.

@acalinoob4534 2 месяца назад

@@moccasinmarine thank you for the update! I can 100% confirm I was contacted to the start position instead of the on/ run position. I will be sure to try this!!