1966 C2 Corvette RideTech Front Suspension installation. Part 1 of 2

Подписаться 2,9 тыс.

Просмотров 1,4 тыс.

50% 1

This 1966 C2 Corvette project gets it's new RideTech front suspension installed in this very detailed video. If you are planning an upgrade to your C2 C3 Corvette suspension you might find this video very helpful. This is part 1. Part 2 will show installation of steering box, brakes, and sway bar.

Опубликовано:

31 июл 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 10

@jedandmissymartin1891 7 месяцев назад

i will be doing the same setup on my c2. thanks for the videos!

@scottmoto 8 месяцев назад

Spending the bucks, hey?? LOL. Frame looks great. That suspension is a great addition.

@DickShaw 8 месяцев назад

Trying to do it right, $$$ is part of it :). Thanks for watching and for your comments.

@ronaldwarren5220 6 месяцев назад

I bet you played with erector sets as a kid.

@KAvery17 3 месяца назад

I just installed the same Ridetech retention kit and my hub was way off. Did you happen to check the runout? I’ve got a replacement set coming but if those are off I’m not sure how to shim. Is this something I should be worried about? The bearing didn’t have but maybe .001 or .002 of play when I measured as you did in the video. The rotor only exaggerated the runout caused by the hub. Thanks again for all your help.

@DickShaw 3 месяца назад

Not sure what to tell you. Mine both ran true. If your rotors are wobbling then something was not machined correctly. There will be no way to shim for that. If the caliper is not square with the rotor then you could shim one side to make it right.

@darlasimons 3 месяца назад

I am wondering about the cost difference between a Ride Tech complete suspension vs. a aftermarket chassis?

@DickShaw 3 месяца назад

I think you would spend at least 4 times on the complete chassis. I looked into this option and decided to stick with the stock frame using the RideTech components.