No video :(

1988-1995 Toyota Pickup/4runner Tune Up How-to

Подписаться 27 тыс.

Просмотров 4,1 тыс.

50% 1

This video will show you how to do a tune up on the 1988-1995 Toyota truck and 4runner including spark plugs, spark plug wires, distributor cap and rotor equipped with the 3VZ-E 3.0 V6 engine. All parts were purchased from Amazon and I will provide links to them below.
NGK Spark Plugs: amzn.to/3rxB8Ge
Walker Spark Plug Wires: amzn.to/3OsUmpO
Bosch Distributor Cap: amzn.to/44QoMr2
Bosch Ignition Rotor: amzn.to/3O6qptY
Spark Plug Gapper Tool: amzn.to/3Y5UVIY

Опубликовано:

26 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 8

@hawkeye7435 5 дней назад

😊😊😊😊😊

@o0XFernX0o 7 месяцев назад

How would i fimd TDC again? I screwed up the first time i installed the distributor so i gotta re do it.

@BLUECOLLARGARAGE 7 месяцев назад

You will need to pull the spark plug on cylinder #1 which will be the first one closest to the radiator on the passenger side. After the spark plug is removed you can either stick a long screwdriver or an extension down into the spark plug hole so it will be sitting on top of the piston. Next go ahead and rotate the crankshaft by hand using a socket wrench on the crankshaft pulley going clockwise and watch the screwdriver it will go up and down as you rotate the crankshaft when the screwdriver comes all the way up on cylinder number 1 then you know it will be at top dead center.

@o0XFernX0o 7 месяцев назад

@@BLUECOLLARGARAGE but there's 2 TDC so how do I know I'm on the compression stroke???

@BLUECOLLARGARAGE 7 месяцев назад

@@o0XFernX0o you will need to either take off the timing cover so you can see the marks on the cam sprockets or you can use a vacuum gauge with the compression tester adapters that screw into the spark plug hole. With this method you will need to have a vacuum gauge that measures psi and vacuum.