1996 Sea-doo GSX Info Gauge repair 

I imagine this procedure will work for my '96 GTX (triple gauges)... very good detail. thanks.

The way you opened up the gauge is also an old school Hack people use a lot of times to set the mileage back on analog speedometers. It has gotten so bad that when I go look at buying a dual sport motorcycle, or anything with a analog speedometer, I check to see if the cap has been opened up with a screw driver. Sooo many times I have not purchased a bike because this hack was done. Very easy to spot due to the fact you have to mash that lip back down when you put it back together, and can plainly see where the prying marks were. Great job though. I picked up a newsed 99 GTX Limited the other day that needs this done. 👍

Where do I get the gauge film

Very useful. Thank you very much.

How did you get the bezel out?

Great video - big help! Thank you

How do you get the gauge out?

You didn't use silicone or adhesive?

Also paint can opener will be faster/easier than a flatbalde screwdriver.

Can you explain to me how you got the gauge out you skip that whole step my problem is my gauges won't turn on everything else works the beep sidhu Works amazing turns on no problem but my gauges won't turn on so I want to get to them and make sure the wiring is connected properly but how did you get in there thank you please help

Was the polarizer film you used clear? Only stuff I can seem to find is tinted? Or is that correct?

Hey I’ve got 2 1996 gsx 800. We are having a lot of trouble with fouled plugs what are your suggestions to do ? Thanks

How about if you get a B-1655 lock out code? And how do you clear the code? (2005 GTX)

I did this for my 01 seadoo gtx rfi and the gauge quit working afterwards. Any idea what happened or what to check?

krylon satin iris paint is a pretty good match to repaint that front weathered plastic just FYI, otherwise using a propane torch to melt it from a distance works pretty good too

Hello, I am trying to revive my gsx is it possible to get in contact with you guys?

This has been a lot of help so far! My circuit board doesn't want to slide to push the screen out. Any suggestions?

Would a heat gun work?

What kind of plastic and where do I buy it to replace on my gauge

Can't you just replace this with an analog gauge from another Seadoo?

OSD Marine sells a kit for 16 bucks to redo this too

So why put another film on it?

Where did you get the film?

25mm Olfa blade would work better

You can do away with all the DESS crap with an aftermarket MPEM, as they are not lanyard specific and are relatively affordable at between $90-$120