This is a 2006 Honda Accord Master power window switch remove an install video. This part is pretty easy to remove and replace. Make sure to use a plastic pry bar to remove the trim panel or else you can cause damage to the plastic piece. Also we'll show you how to reset your Auto window button switch so that it'll start working again.
Tools:
amzn.to/2bdCm1Y Plastic pry bar
amzn.to/2awcdGr Phillip screw driver
Parts:
amzn.to/2b8Wkpk Master power window switch (Fits EX model only, it does not fit LX model)
Torque specs:
hand tight
If your key fob doesn't work, follow this procedure to reprogram it.
KEYLESS ENTRY PROGRAMMING
Have all remotes for the vehicle on hand.
Make sure all the doors and rear hatch/trunk are closed during programming.
Only need to use 1 remote to get into program mode but all remotes must be programmed during the same session.
Each step must be completed within 5 seconds.
1. Sit in the car with all doors/trunk tightly closed
2. Turn the key to the ON position, marked by “II" on the ignition bezel so the dash lights come on, then within 5 seconds press the “Lock" button on the remote for 1 second or so and release the button.
3. Turn the key to the OFF position, marked by “I" on the ignition bezel - dash lights go off.
4. Repeat steps 2 & 3 three more times (A total of 4 times) - each step must be done within 5 seconds of the previous step.
5. Upon the 4th turning of the key to “ON" , press the lock button on one remote, the locks will make a cycling sound (clunk), locks will NOT lock or unlock at this point, they will just make a noise. The system is now in programming mode. Do not turn key off.
6. Within 5 seconds of entering programming mode and within 5 seconds of each other, press the lock button ON EACH remote you are programming, for a second or so and release. This step needs to be completed within 10 seconds. Each time a remote button is pushed, the locks should cycle. Up to 3 remotes can be programmed.
7. Turn ignition completely off and remove the key. Step out of car and close door. The remotes should be programmed and should work. If you have a trunk/hatch release, the button for this feature needs to be held for a few seconds before the trunk/hatch will “pop" .
like and share this video!
If you have any questions or concerns, feel free to leave comments on our FB page.
Like us on Facebook
bit.ly/nutzaboutbolts1
and SUBSCRIBE!
bit.ly/NutzAboutBolts2
Intro: RavenProDesign
www.RavenProDesign.com
Music: Manic Bloom - Death and Conversation
/ manicbloom
27 сен 2015
