2007-2013 Chevrolet Avalanche 5.3L V8 Throttle Body Replacement and Relearn 

Excellent work on showing the printed instructions on the throttle body reset. That is what is needed for those who do not have a scan tool. Shows the DIYer that this can be done safely and correctly IF YOU FOLLOW THE INSTRUCTIONS. DGBryan

thank you, I have the same truck and HAD that problem, but I got a can of Throttle Body cleaner and it helped, did you try that 1st?

My get the code po430 and the mechanic told me change the throttle body so what you think?

U should have let us see how it ran before installing

Did u happen to run out of gas after you drove it around and tested it out? I noticed ur fuel level was.... A bit, low. 🤣😂😛🤦‍♂️

Run at least two cans of carburetor cleaner through that intake, and then put a damn catch can on that engine. Those things should have at least a catch can , that or remove the that the PCV system works so it doesn't run through that intake and oil foul everything around it. I have built a few of these engines and found that General Motors Loves.030 gaps on these piston rings. That is ridiculously large. It sounds like they're getting a kickback from the oil companies to keep these things drinking oil. But at least with a catch can you can put a good portion of that oil back into your crankcase.

good vid, but of all the 30 billion brands you could have picked to use for the replacement, you went with quite possibly the WORST brand for electrical components. take the advice of someone who used to work at autozone, and dealt with their Duralast electrical components, and stay far away from duralast for electrical stuff. they're JUNK. i had to warranty out duralast electrical components at least 3 or 4 times a day when i worked at autozone. and most of the parts were only a couple months old. i strongly recommend going with either standard ignition, delphi, or acdelco.

You don’t need to disconnect the battery? Does your type of scanner allow you to disable the active fuel management (afm)?

I replaced the throttle body but the car not starting

perfect

Umm did you post the pic if the procedure?

Thank you

Can removing the air intake cause a need to relearn the throttle body sensor? Recently had to remove all of it to replace the lifters. 2013 Avalanche is idling like the engine will fall out and the only code is p0300. Replaced MAF, Spark plugs and wires, about to check the o2 sensor but i feel like im just nickel and diming myself to death.

I have chevrolet camaro ss v8 will support?

What is your scan tool

Does this relearn process work on all gm cars I gotta 19 Malibu

should I go get it reprogrammed at the dealership? Or will doing it the way the paper has it should be fine ?

If you at home you should of use instructions everyone doesn't have a programmer

What model scanner is that?

Hey whats the scanner you have?

Anyone that calls a quarter inch rachet a 1 4th inch rachet should never touch a vehicle lol

My shit is idling at 3500 rpm…..