2012 VW Crafter 2.0tdi clutch and flywheelreplacement 

Cheers mate , I’ve ordered another DMF as I pintured the back of the DMF bearing probably by not not having the gearbox completely in the clutch before bolting it in as was heavy as fook and 36 degrees in Spain lol. Weird thing was after fitting , the clutch pedal was down to the floor. Also you have a very good point about being in gear as I might have knocked it into gear underneath trying to get gear selector end rods off. And a local mechanic said I needed a special DMF fitting tool which looking back on your video you used lol so lots of school boy errors on my part lol. Thanks again for your help 👌👍👍

Thanks a lot for this video. One of the best on RU-vid for this particular van. Did the job last Friday, this helped a lot during preparation. When torquing the bolts of the flywheel a block of wood between the teeth of the flywheel and the subframe worked very well to prevent it from rotating. For people who don’t own a pressure bleeder like me: bleeding can be done very fast by pumping the fluid directly into the slave cylinder using a simple oil can and a piece of 6 mm hose.

Helped a lot thanls, takin my clutch out tomorrow .

Brilliant this mate, going to have a go myself, luckily I have got access to a ramp but like the driveway challenge 🤣

You did well there mate not an easy job under those conditions 🙂👍

Great achievement. Mate is doing mine and I'm helping him on his 4 poster ramps. Would like to do it myself till I picked up the Flywheel from the merchants, thought it was nailed to the desk. 👍👍

Great explanaition. Many thx

Nice job buddy

Hi Buddy, Well done, and Good info. this is a job. the parts here in South Africa are Very expensive. thanks best