2014 Ram 2500 Power Wagon ABS Wheel Sensor replacement

Подписаться 39

Просмотров 56 тыс.

50% 1

I was getting the ABS and Traction Control lights on, additionally my 4 wheel drive would not engage (front axle would not lock) and the back up sensor would not work. This is my first video so I apologize about the shakiness and quality of the video.
If you are not sure which wheel sensor is out, test it at the connector with an Ohm meter you should get some resistance, I don't know what the specs are but it should not be an open circuit.

Опубликовано:

23 фев 2019

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 14

@tonymoore9128 Год назад

Thank you!! I kind of got lucky. I broke the bolt hole tab off the Drivers side. Cleaned it and poked it back in and went to the parts store. Replaced it with a new one and still had the lights on. Cleaned the passenger sensor and it worked. Lights are off now. I assume the one I broke was bad and the other was dirty. Thanks again.

@Hennes003 11 месяцев назад

Simple enough. Thanks for the info!

@rickgifford42 Год назад

What was that chunk of metal, what did you repair? Thank you for the video.

@ShortboyKennel 5 лет назад

So how long did it take? My 14 ram has the abs light on now and I can feel it in the wheel. Can you tell me how you used the ohm meter to check.

@rjonk3698 5 лет назад

Shortboy Kennels sorry I’ve been out of town with limited connection. It took me over an hour since I had to take the disc/drum off. Disconnect the abs cable (see 1:36) and utilize each prob of the Ohmmeter on the sensor side of the connector. A bad sensor will give you an Open (or infinite) reading.

@stanleysaucedo3053 11 месяцев назад

Please use a jack stand as a safety device ✌️

@traviswagner9822 2 года назад

Their is a difference. Especially in price.

@hiseminencetheholymacdiarmada 4 года назад

I couldn’t get my rear ones unclipped to test them, I didn’t want to pull too hard and break them. How do they come apart? I noticed here was a red tab that seemed to slide back and forth as some sort of lock but I couldn’t disconnect it to test it.

@rjonk3698 4 года назад

I remember it was it was really tricky to get to in the first place and then the connectors are on there very snug. There is a little tab that you have to lift before you can separate the clip, its just a matter of getting to it. If you search part number su15354 on Autozone's website. It's kind of hard to see what the connector looks like but it should give you some idea of what your facing.

@hiseminencetheholymacdiarmada 4 года назад

I got them off eventually, was able to test them and they all tested good. Oddly enough, I went over a speed bump in a parking lot rather fast and it must have jarred something somewhere because the lights went off and haven’t come back on since... wtf??? Lol, I’ll take it