Thanks for this video. I responded to your earlier video on the boat in general. I am in the process of refitting a new RIPTIDE TERROVA 80 on my 2019 (same exact boat). Will be cutting my hole out in a few days. Had to get a 2 gang version for my cut out.(hands too big). It should work out fine. Couple of ?'s Did you use 4 inch 1/4 x 20 stainless panhead machine screws or or stainless 1/4 x 20 bolts. The bolts are threded only an inch or so. Also, do you know the diameter of the cut out hole for the plug?
Yeah I used Phillips head machine screws for the mounting bolts. The hole I cut in my plate was 7/8". It's the standard size for a nominal 1/2 electrical knockout. Hope this helps good luck!
