At first I thought you were going to make an AKA "suicide cord" but alas it was not the case, lol. Do you ever use NO-OX-ID on wiring projects? I love that stuff and regret not investing in it sooner. Anything I take apart with mid to high amperage flow that does not have it gets some on reassembly. Only failure with the stuff or not so much failure but unwanted side effect was I used it extensively over a year ago on the 30+ wire rope clamp jumpers I put in on the electric fence on the old patches to increase conductivity on the rusty barb wire and various other wire used as a hot wire. When I decided to stop patching and replacing everything I came back across all these jumpers while running new wire and they were covered in way too much dust and debris to my liking. Now that I replaced all the hot wire I have stopped using it at wire rope clamped jumpers as I am clamping fresh galvanized wire together and the likelihood of carbon buildup in a clean clamped jumper is very small for this area. I have also been running high and low hots to have that dual layer of protection to project Alcatraz to make sure it is as failproof as possible.
