Just put some thick washers so you don't run into the end of the threads..but you can replace that U bolt for $2 at home depot..the part that has the 3/8 drive is the only thing that matters
I used one, worked great in my case on a '95 T-bird, but in use the U-bolt deforms or bends just a hair, enough that the threaded ends get close enough to make easy insertion into saddle a PITA, but a short pipe and trip to the vise to spread them back a hair cures it. I collected both inner and outer tie rod ends and boots before taking the OEMs off as single units, I matched lengths, finished up, had 1/16" toe out. Steering wheel was centered though, so very easy adjustments and re-check fixed it all. 5/32" toe in now.
Hey bro get off those nutz and get you some case hardened grade 8 or 10. Then double up on them to lock them down so they wont damage the threads when you torque the tool. Should be fine just split those old ones off and clean up the threads. Looks like a good design tool but they need to use size like 1/2 or more.
Your right. I actually bought thr OEM Tools version a couple months after making this video and it works amazing. Ive done over 5 jobs and its still going strong
Tough one as for the DIY it's probably worth it but not the shop tool. Could be a case of over torquing thinking you needed more bite then you actually did. I purchased one on Amazon and will give it a shot and see how it goes. It was worth watch your review. Thanks.
Heck I use the Harbor freight 1/2 torque wrench for a Breaker bar..its was only $5 with a membership so cheaper than a breaker bar. I use a the good torque wrench for specs
Frankly any type of grab it thingy, an exhaust clamp that you roughed up, etc. That will give you enough stuff to grab with big vice grips or whatever and be able to turn and break loctite. You don't need any sort of ratchet except for convenience. Once you break the threads loose it is easy to spin the rod in or out. And it looks like this tool he bought is cheaply made. A throw away exhaust clamp seems more better
Thanks for the review and walk through on how to use it. Could you possibly just cut off that cheap u-bolt and replace it with one that's better quality ?
Did it have a brand? I see lots of no-name brand ones but also some from more recognizable brands on amazon. The cheapie no-name ones seem to have those washers, whereas the branded ones have a nut with a captive washer and serrated edges.
Send it back. I return from Ebay and Amozon all the time. It like a free tool rental. I only send back the poor quality stuff, I dont abuse the return policy.
