@@MdMohsin-lv1tz yea that is the perfect combo. 1.1mm orifice with an mjjc foam pro and youre good. The highest foaming soaps I’ve used are 1. DIY Detail incredible suds 2. Mirror Finish polished Atomic Bomb 3. Adams Mega Foam
The actual point of the foam cannon is the make it easier to wash your car while in direct sunlight. If you have proper output, the foam should be thick and stick on the surface. This makes it so by the time you’re halfway around the car, the other half is still foamed and protected from the hot rays of the sun, reducing the chance of streaking or water spotting.
Well that's one reason.. another is for a pre wash, you should foam, let it sit then rinse, foam again then wash. I do rinseless washes now though wayyyy more time efficient drying feels way slicker
The active 2.0 and the Ve52 it’s recommended not to use the 1.1 mm office though from what I’ve read? It make the pressure washer surge since it’s not made for to be used with a 1.1
Hey can you guys make a super high quality 1/2” quick connect like you do for the m22 adapters hard to find good quick connects made with quality stainless steel
@@mckillans I would love to 1. Have better products in the market such as the ones you provide, 2. Support your business if you decide to start developing that or release that product make a video and I’ll be your 1st customer 😂
You aren't getting 2 gpm on most electric pressure washers, nor is it needed. For some reason obsessed garage got everyone to think that you need more water. It might save a little time, but only very little time, and your water usage will increase. As far as cleaning ability, it really isn't all that important to hunt down an especially high flow pressure washer, unless you're in a high volume detailing environment.
My dad just bought a 2023 Dacia Duster and he takes it off-roading sometimes but it gets dirty really quickly, any tips on what products I should start out with to clean the car?
I would deep clean and polish the paint up then ceramic coat it. It lasts about a year and all you need is to rinse off the car with water. When it starts to fade off in some spots, you can use a detailling spray that has ceramic in it to touch it up and make it like new! Id reccomend watching some videos from chemical guys channel. They go in depth of how to take care of your vehicle :)
It's the 1.1 mm orifice a smaller or bigger diameter than the orfice that's already inside of the foam Cannon thing? The orifice on the phone Cannon thing that I have looks like the hole is bigger than the 1.1 mm that I ordered on Amazon after watching this video.
Hell yeah! But only use around 1000 psi, you dont need much pressure to get good foam or to clean a car. Gas powered tend to be significantly more powerful than electric, be careful not to damage the relatively sensitive vehicle surfaces.
So bad advice , you risk a lot with foam cannons , sun , waterspots, buckets methode with pre spray ikfoam is fast , same result, hope you guys take note
Not true detailers would rather have quality over quantity because the better the vehicle is cleaned the better the chances to gain potential customers through that customer would reference friends and family relatives to call and book car detailing appointments but for some who just wants to clean their car is up to them to use a foam cannon or not